9SS1 Start-Stop Output Module
Instruction Manual
Typical wiring diagram
Application
Start Stop or High Low Level Set Mode to: One Burst Transmission ON ON
https://electrodepot.com/manuals/9SS1 Start/Stop Output Module
Two input from the receiver relay
One output to energize the external contactor
Transmitter send a momentary pulse via Channel
One (1) to START; the Receiver Control Module
Output turns ON
It will stay ON Until the transmitter sends the STOP signal via Channel Two (2) to turn the Receiver Output OFF
Radio control equipment in not to be used in life safety.
Installations shall be performed by a certified professional
Documents / Resources
![]() |
Electrodepot 9SS1 Start-Stop Output Module [pdf] Instructions 9SS1 Start-Stop Output Module, 9SS1, Start-Stop Output Module, Stop Output Module, Output Module, Module |