elcometer 510s Automatic Adhesion Tester User Guide
1 GAUGE OVERVIEW
2 BOX CONTENTS
3 USING THE GAUGE
4 GETTING STARTED
4.1 FITTING THE BATTERIES
4.2 SELECTING YOUR LANGUAGE
4.3 SCREEN SETTINGS
4.4 SETTING UP THE READING DISPLAY
4.5 SELECTING THE MEASUREMENT UNITS
The Elcometer 510 Model S can display pull test results in MPa. psi, Newtons or N/mm2. To select the measurement units, press Menu/Setup/Units.
4.6 SELECTING THE DOLY SIZE & PULL RATE
5 SECURING THE DOLLY
5.1 USING 10mm, 14.2mm OR 20mm DOLLIES
5.2 TESTING COATINGS ON CONCRETE USING 50mm DOLLIES
6 ATTACHING THE GAUGE TO THE DOLLY
7 PERFORMING THE TEST
8 ASSESSING THE RESULTS
8.1 EXAMINING THE DOLLY
8.2 EXAMINING THE DOLLY (COATINGS ON CONCRETE)
9 BATCHING
9.1 BATCH FUNCTIONS
9.2 CREATING A NEW BATCH
10 REVIEWING BATCH DATA
10.1 BATCH STATISTICS (Batch/Review Batch/Statistics)
10.2 BATCH READINGS (Batch/Review Batch/Readings)
11 VERIFYING THE GAUGE CALIBRATION
13 DOWNLOADING DATA
14 UPGRADING YOUR GAUGE
15 SPARES & ACCESSORIES
15.1 DOLLIES
15.2 DOLLY CUTTERS
15.3 DOLLY SKIRTS
15.4 MAGNETIC ANCHOR CLAMP
16 ADHESIVES
17 WARRANTY STATEMENT
18 TECHNICAL SPECIFICATION
19 LEGAL NOTICES & REGULATORY INFORMATION
Documents / Resources
 |
elcometer 510s Automatic Adhesion Tester [pdf] User Guide 510s Automatic Adhesion Tester, Automatic Adhesion Tester, Adhesion Tester |
