TCS100 Sensor Specification

1. Safety Instructions

Please read this manual carefully before using the product. Be familiar with the structure of the product and master the installation method. Before installation, please confirm that the product accessories are complete, the product can work normally, and there is no abnormal appearance or structure. During the installation process, the company shall strictly abide by the maintenance operation specifications and use professional maintenance tools. Otherwise, Shenzhen Xlink Electronics Co., Ltd. will not be responsible for any problems caused by the customer's illegal operation. If there is any problem in the process of using the product, it must be replaced or stopped immediately and tested by professional maintenance personnel or after-sales service. After installing the product, be sure to re-measure the dynamic balance of the tire to eliminate safety risks.

2. Parameters

Product Model: TCS-100
Storage temperature: -10℃~50℃
Operating temperature: -40℃~125 ℃
Pressure monitoring range: 0-900Kpa
Waterproof grade: IP67
Battery life: 3-5 years
Power Level: -33.84dBm
Frequency: 314.9MHz
Pressure accuracy: ±7Kpa
Temperature accuracy: ±3°C
Weight: 26g (With valve)
Dimensions: approx. 72.25mm*44.27mm*17.63mm
Warranty: 2 years

3. Sensor Component diagram

A diagram showing the TCS100 sensor. The diagram illustrates the sensor's main body with a metal valve stem attached.

4. Installation Operation Steps

Pass the nozzle through the hub and fix it with the nozzle fixing nut. Note that it is not tightening.
Illustration of passing the sensor nozzle through the wheel hub.
Fix the sensor on the air nozzles with the sensor fixing screw. Note that the sensor should be close to the hub with a torque of 4N•m.
Illustration of attaching the sensor to the air nozzle with a screw, indicating a torque of 4 N•m.
Tighten the air nozzle fixing nut with a wrench to complete the installation. Note that the wrench uses a torque of 7 N•m.
Illustration of tightening the nozzle fixing nut with a wrench, indicating a torque of 7 N•m.

FCC Compliance Information

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.