EKVIP 022428 Light Net Lysnett LED Connectable System
SAFETY INSTRUCTIONS
- Intended for indoor and outdoor use.
- For decorative lighting use only.
- The product is not intended for general lighting.
- Do not connect the product to the mains power supply while the product is still in the pack.
- The power cord on this product is not replaceable, if damaged discard the complete product.
- Do not expose the power cord or conductors to mechanical loads. Do not hang objects on the product.
- Choose a suitable place to put the product where it is not causing an obstruction or a hazard.
- Do not expose the product to water, moisture or heat, and do not use in very humid conditions.
- Do not expose the product to direct heat, or use in the vicinity of naked flames, orsubmerge in water.
- This is not a toy. Be careful if using the product near children.
- Recycle the product at the end of its useful life in accordance with local regulations.
WARNING!
The product must only be used when all the seals are correctly fitted.
Symbols
 |
Read the instructions. |
 |
Safety class II |
 |
Approved as per applicable directives. |
 |
Recycle discarded product in accordance with local regulations. |
TECHNICAL DATA
| Rated voltage | 230 V ~ 50 Hz |
| Output | 9.2 W |
| No. of LEDs | 100 |
| Safety class | II |
| Protection rating | IP44 |
| Size | 170 x 200 cm |
USE
- Remove the product from the packaging.
- Place the product in the required location
- Insert the plug into the mains power supply.
Documents / Resources
 |
EKVIP 022428 Light Net Lysnett LED Connectable System [pdf] Instruction Manual 022428, Light Net, Lysnett LED Connectable System, Light Net Lysnett LED Connectable System, 022428 Light Net Lysnett LED Connectable System, LED Connectable System, Connectable System |
