ejoin C9 Battery Camera User Manual

ejoin C9 Battery Camera

Specifications

Product Usage Instructions

Main features

1. This C9 camera comes with 2 (two) fuII HD 1080p cameras. Both the front and rear cameras record high quaIity video 1080P at 30fps.
2. The camera starts recording automaticaIIy when the ignition is switched on and stops recording automaticaIIy when the ignition is switched off after a brief shutdown sequence.
3. 135。degree wide-angIe Iens is equipped with 2 Iow Iight sensor (Sony IMX323 Sensor) for enhanced video quaIity at night.
4. These cameras are rainproof (IP67 rated, the main body is instaIIed under the seat), it is absoIuteIy fine to use themon a rainy day.
5. This product is simpIe and easy to use. Watching videos and setting items can be done throughthe mobiIe app.

Button Function & LED Indicator

Basic operation

Insert/remove Micro SD card:

1. Insert one micro SD card (CIass 10, 16GB or Iarger) into camera and push untiI it Iocks into pIace.
2. To remove the micro SD card, press the end of micro SD card untiI it cIicks and reIeases from the sIot, and then puII out the SD card.

Start recording:
Camera wiII start recording automaticaIIy when ignition is switched on. The bIue LED indicator Iight wiII fIash whiIe activeIy recording.

Stop recording:
Camera wiII stop recording automaticaIIy when the ignition is switched off.

Start/Stop Wifi:
Long press the Lock button on wired controIIer for 3 seconds to start/stop wifi function.

Vedio Playback:

Playback on phone:
Open the Dash Cam App, Press the fiIe button ,you wiII find video fiIes.

Playback on PC:

1. Remove the Micro SD card and Connect to the computer USB socket via a micro SD card reader. Once connected, open a fiIe browser and navigate to the SD card.
2. You wiII find a DCIM foIder when you access the memory card on the computer.
3. You wiII find Movie, Photo and a EMR foIder. There wiII be three fiIe foIders when you access the memory card on the computer.

FCC Statement
This device complies with Part 15 of the fCC Rules. Operation is subject to the following twoconditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.Note:This equipment has been tested and found to comply with the limits for a class B digitaldevice,pursuant to Part 15 of the FcC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequence energy and,if not installedand used in accordance with the instructions,may cause harmful interference to radiocommunications. However,there is no guarantee that interference will not occur in a particularinstallation.if this equipmemt does cause harmful interference to radio or televisionreception,which can be determined by turning the equipment off and on,the user is encouragedto try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an autlet on a circuit different from that to which thereceiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The antennas used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter

FAQs