EG4 ELECTRONICS Brightmount Fixed Angle Ground Mount System
PARTS DIAGRAM
DIMENSIONS AND LAYOUT
INSTALLATION
Tools needed
- A Install leg group Using a M8’80 boli, M8 washers, M8 nut Install the U45 connector as shown to the right
- B Install mounting bracket using M8’65 bolts, M8 washers and M8 nuts to connect the legs to the mounting bracket as shown to the left
- C Install ‘L’ foot M8’65 bolt, M8 washers, and M8 nut to Install the “L’ foot.
- F Connect the frames together using Junction brackets, and M8 allen bolts
- Completed cunstructlon.
- Install PV modules using the End & Mid clamps.
- H Install earth lug on the end of the rails.
www.eg4electronics.com support@eg4electronics.com Sulphur Springs. TX Dec 2022 Ver 1.1.0 1 Specifications subject to change without notice
Documents / Resources
 |
EG4 ELECTRONICS Brightmount Fixed Angle Ground Mount System [pdf] Installation Guide Brightmount Fixed Angle Ground Mount System, Fixed Angle Ground Mount System, Angle Ground Mount System, Ground Mount System, Mount System |
