DoorBird D21X Light Push Buttons - logoD21X Light Push Buttons
Installation Guide

INSTALLATION D21X LIGHT PUSH BUTTONS

INSTALLATION D21X LICHTTASTER
D21x rectangular light push button
D21x rechteckiger LichttasterDoorBird D21X Light Push Buttons - figure 1

Make sure that the light switch is aligned upwards according to the „UP“ marking and surrounded by the silicone seal.
Plug the enclosed yellow cable into the „Switch“ connection on the light switch and then connect it to the yellow cable of the main unit.
The „Light Switch“ connection is a potential-free contact that can be used, for example, to control a time relay (max. 24 VDC/VAC, 1 A) to switch the staircase lighting. Use the enclosed pink cable for this purpose.

DoorBird D21X Light Push Buttons - figure 2

The round light switch provides a connection for the power supply of the integrated LED of the button (12-24 VDC / VAC) and an open/closed potential-free contact, which can be used e.g. for the control of a time relay (max. 24 VDC / VAC, 1 A) to switch the staircase lighting.
REL NO: Normally open.
REL  NC: Normally closed.

Documents / Resources

DoorBird D21X Light Push Buttons [pdf] Installation Guide
D21X, Light Push Buttons, D21X Light Push Buttons

References

Leave a comment

Your email address will not be published. Required fields are marked *