Quick Start Guide
Converter plate for
electronic gang box
DWC-GPLT-W
DWC-GPLT-W Converter Plate For Electronic Gang Box
WHAT’S IN THE BOX
| Option A Installation Screws |  |
4 |
| Option B Installation Screws |  |
2 |
| Camera Mounting Screws |  |
3 sets |
NOTE: Download all your support materials and tools in one place.
- Go to: http://www.digital-watchdog.com/resources
- Search your product by entering the part number in the ‘Search by Product’ search bar. Results for applicable part numbers will populate automatically based on the part number you enter.
- Click ‘Search’. All supported materials, including manuals and quick start guide (QSGs) will appear in the results.
NSTALLAT I ON
- Connect the converter plate to an electric gang box.
Use the 4 screws (A) included with the converter plate when using a 2-gang handy electrical box or switch box.
Use the 2 screws (B) included with the converter plate when using a 1-gang handy electrical box.
- Pass wires through and make the connections.
Use the CABLE-OUT spaces in the converter plate. - Follow the table below to connect the camera to the appropriate mounting points and which screws set to use.
Mounting holes Compatible cameras Screw size Mounting point 1 DWC-V4 models 120mm screws 20mm screws DWC-MV4 models 120mm screw 20mm screw DWC-V6 models 20mm screw 20mm screw Mounting point 2, 2# DWC-MF and DWC-MPF models 120mm screw 20mm screw DWC-MV8 and DWC-MPVB models 23mm screw DWC-MVC and DWC-MPVC models 20mm screw DWC-MVD and DWC-MPVD models 35mm screws DWC-PVF and DWC-PPVF models 20mm screw Mounting point 4 DWC-MV7 and DWC-MPV7 models 20mm screw DWC-V7 models 20mm screw DWC-MVA and DWC-MPVA models 20mm screw DWC-VA models 20mm screw DWC-D4 models 20mm screw DWC-MF and DWC-MPF models OLD HARDWARE 20mm screw + rubber gasket I DWC-MV8 and DWC-MPVB models OLD HARDWARE 20mm screw + rubber gasket DWC-PVF and DWC-PPVF models OLD HARDWARE 20mm screw + rubber casket Mounting Point 5 DWC-D3 models 20mm screw DWC-MD7 models 20mm screw Mounting point 6 DWC-MD4 models 20mm screw - Mount the camera to the upper side of the converter plate.
* NOTE: How to tell what MF, V8 or PVF hardware you have:
If the camera’s mounting holes are located on the outer edge of the camera’s base, use mounting points labeled as “2, #2” WITHOUT the included rubber gaskets.
If the camera’s mounting holes are located on the inner edge of the camera’s base, use mounting points labeled as “4” WITH the included rubber gaskets.
Rev:06/23
Copyright © Digital Watchdog.
All rights reserved.
Specifications and pricing are
subject to change without notice.
Documents / Resources
 |
DIGITAL WATCHDOG DWC-GPLT-W Converter Plate For Electronic Gang Box [pdf] User Guide DWC-GPLT-W, DWC-GPLT-W Converter Plate For Electronic Gang Box, Converter Plate For Electronic Gang Box, Plate For Electronic Gang Box, Electronic Gang Box, Gang Box, Box |