Danfoss VICSC302 Speed Up Heat Panels Installation Guide
Installation of Speed Up Heat Panels in Dry Installations
- Fig. 1: Install Speed Up perimeter insulation and support batten on dry, even and load bearing substrate.
- Fig. 2: Following the layout, begin the installation in one corner with a Speed Up header panel.
- Fig. 3: Place the Speed Up heat panels (CZ: pipe distance 250 mm, EZ: pipe distance 125 mm). Fill gaps and unheated areas with blank panels.
- Fig. 4: Snap the pre-scored heat panels as required.
- Fig. 5: Light constructions (e.g. laminate/engineered timber or strong board constructions laid directly on the heat panels): rooms > 12 m² glue all perimeter and header panels, rooms < 12 m² glue all panels (recommended).
- Fig. 6: Where required cut individual pipe channels using the Speed Up hot wire cutter.
- Fig. 7: Support battens in thresholds should be screwed down.
- Fig. 8: Holding the pipe in a large curve to avoid tension, press the composite pipe into the channels. Avoid lifting pipe once installed in the header panels.
- Fig. 9: Press fittings should only be positioned between two aluminum sheets and never in curved sections of pipe.
- Fig. 10: Cover pipe work in front of manifold with Speed Up load bearing steel to protect against damage.
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
VICSC302 Produced by Danfoss Heating Solutions © 11/2010
Danfoss A/S
Heating Solutions
Haarupvaenget 11
8600 Silkeborg
Denmark
Phone:+45 7488 8000
Fax: +45 7488 8100
Email: ComfortControlsInternet@danfoss.com
www.heating.danfoss.com
Documents / Resources
 |
Danfoss VICSC302 SpeedUp Heat Panels [pdf] Installation Guide VICSC302 SpeedUp Heat Panels, VICSC302, SpeedUp Heat Panels, Heat Panels, Panels |
