Danfoss RAV Ally Radiator Thermostat
Product Specifications
- Transmission Frequency: 2.4 GHz
- Transmission Power: Less than 40 mW
Product Usage Instructions
Installation Instructions
Remove the cover as shown in the diagram and insert 2 AA batteries. Ensure correct battery placement. Screw the Danfoss AllyTM knob onto the mounted adapter until it clicks. Press and hold the knob for 3 seconds. The temperature setting will be displayed on the screen once mounted. Make sure to mount the thermostat on the valve in ‘M’ mode to prevent damage.
Disposal Instructions
The thermostat must be disposed of as electronic waste according to local regulations. Please use the manual provided with your gateway and follow the instructions to download the App.
The adapters from the right side are included. Remaining adapters in the overview above must be purchased separately. Adapter code numbers can be found below each adapter illustration.
How to mount the thermostat
Remove the battery cover as shown in the diagram and insert two AA batteries. Make sure the batteries are correctly oriented. Screw the Danfoss Ally™ onto the mounted adapter until a click sound appears. Press and hold the button for 3 seconds. The temperature set point will show on the screen once the Danfoss Ally™ is mounted.
CAUTION!
Mounting onto the valve must be done in “M” mode, otherwise, that could cause the thermostat damage.
How to reset the thermostat
- Remove the cover and take out one battery.
- Press and hold. Keep holding while reinserting the battery. The screen will go blank after approximately 3 seconds.
- Continue system setup in the App.
Download Guide
Transmission Frequency: 2,4 GHz
Transmission Power: < 40 mW
The thermostat must be disposed of as electronic waste.
Safety precautions
SIMPLIFIED EU DECLARATION OF CONFORMITY Hereby, Danfoss A/S declares that the radio equipment type Danfoss Ally™ complies with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.danfoss.com
The thermostat is not intended for children and must not be used as a toy. Do not leave packaging materials where children may be tempted to play with them, as this is extremely dangerous. Do not attempt to dismantle the thermostat as it contains no user-serviceable parts.
- Danfoss Ltd.
22 Wycombe End, HP9 1NB, GB - Homepage
www.allyapprovals.danfoss.com
Danfoss cannot accept any responsibility for possible errors in catalogs, brochures, videos and other material. Danfoss reserves the right to alter its products without notice. This also applies to products ordered but not delivered, provided that such alterations can be made without changes to form, fit or function of the product. All trademarks in this ma-terial are property of Danfoss A/S or Danfoss group companies. Danfoss and the Danfoss logo are trademarks of Danfoss A/S. All rights reserved.
FAQs
Q: How do I mount the thermostat?
A: Follow the instructions provided in the user manual. Ensure correct battery placement and mounting in ‘M’ mode on the valve to prevent damage.
Q: What is the transmission frequency and power?
A: The transmission frequency is 2.4 GHz, and the transmission power is less than 40 mW.
Documents / Resources
 |
Danfoss RAV Ally Radiator Thermostat [pdf] User Guide RA, RAV, RTD, RAVL, M28, M30, GIACOMINI, RAV Ally Radiator Thermostat, RAV, Ally Radiator Thermostat, Radiator Thermostat, Thermostat |