Danfoss FH-WC Connection Bo
Specifications
- Model: FH-WC Connection Box, 230V
- Brand: Danfoss
- Power Supply: 230V, 50Hz
- Max. Load: 10W/50mA
- IP Rating: IP21 T30
The installation must be done by an authorized and qualified installer according to local regulations.
Installation
Before installing the FH-WC Connection Box, ensure that the power supply is turned off. Follow these steps:
- Locate a suitable mounting location for the connection box.
- Connect the necessary cables (L, N, PE) as per the provided diagram.
- Securely mount the connection box using appropriate fixtures.
- Turn on the power supply and ensure proper functionality.
Usage
To use the FH-WC Connection Box with Danfoss IconTM devices, follow these steps:
- Connect the Danfoss IconTM Dial or Display to the FH-WC according to the provided instructions.
- Ensure the load does not exceed the specified limits to avoid damage.
- For programmable features, refer to the specific device manual for programming instructions.
FH-WC + Danfoss Icon™
FH-WC + BasicPlus2
Danfoss A/S
Floor Heating Hydronics • Ulvehavevej 61 • DK-7100 Vejle • Denmark • Phone: +45 7488 8500 • Fax: +45 7488 8501 heating@danfoss.com • www.floorheating.danfoss.com
Danfoss can accept no responsibility for possible errors in catalogues, brochures, and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already
on order, provided that such alterations can be made without subsequent changes being necessary in specifications already agreed upon.
All trademarks in this material are the property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Frequently Asked Questions
- Q: Can I install the FH-WC Connection Box myself?
A: Installation should be carried out by a qualified electrician in accordance with local regulations to ensure safety and proper functioning. - Q: What is the maximum load supported by the FH-WC Connection Box?
A: The FH-WC Connection Box supports a maximum load of 10W/50mA. - Q: Where can I find additional programming instructions for the Danfoss IconTM devices?
A: Refer to the specific manual provided with the Danfoss IconTM Dial or Display for detailed programming guidance.
Documents / Resources
 |
Danfoss FH-WC Connection Box [pdf] Installation Guide 088H0016, 088N2916, 088N3452, 088N3454, 088U0622, 088U0626, FH-WC Connection Box, FH-WC, Connection Box |