Danfoss 130BB781.10 VLT HVAC Basic Drive Instruction Manual
Mounting Instruction
Step 1
Fit top cover onto frequency converter.
Step 2
Mount metal bracket onto frequency converter and tighten two M4 X 10 screws.
Tightening torque: 2Nm
Step 3
Fit bottom cover onto frequency converter and tighten a M4 X 10 screw.
| Type 1 Kit | |
| Frame | Conduit Size |
| H1 | Ø22.5mm X 5 |
| H2 | Ø22.5mm X 2, Ø28.4mm X 3 |
| H3 | Ø22.5mm X 2, Ø28.4mm X 3 |
| H4 | Ø22.5mm X 2, Ø34.7mm X 3 |
| H5 | Ø22.5mm X 3, Ø34.7mm X 3 |
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material Danfoss reserves the right to alter its products without notice. This taro applies to products ready on order provided that such cessations can be made without sub sequential diagnoses being necessary in specifications alkoxy agreed Al trademarks in this material are property of the respects companies. Sanford and the Danfoss Ergo type are trademarks of Fonda A/S. All rights reserved.
Documents / Resources
 |
Danfoss 130BB781.10 VLT HVAC Basic Drive [pdf] Instruction Manual 130BB781.10, 130BB787.10, 130BB786.10, 130BB781.10 VLT HVAC Basic Drive, 130BB781.10, VLT HVAC Basic Drive, HVAC Basic Drive, Basic Drive |
