Danfoss-LOGO

010205 Danfoss Ally Radiator Thermostat

010205-Danfoss-Ally-Radiator-Thermostat-PRODUCT

Please use the manual provided with your gateway, and follow the instruction to download the App.

010205-Danfoss-Ally-Radiator-Thermostat-1

The adapters from the right box side are included. Remaining adapters in the overview above must be purchased separately. Adapter code numbers can be found below each adapter illustration.

010205-Danfoss-Ally-Radiator-Thermostat-2

How to mount the thermostat. Remove the battery cover as shown in the diagram and insert two AA batteries. Make sure the batteries are correctly oriented. Screw the Danfoss Ally™ onto the mounted adapter until a click sound appears. Press and hold the button for 3 seconds. The temperature set point will show on the screen once the Danfoss Ally™ is mounted

010205-Danfoss-Ally-Radiator-Thermostat-3

How to reset the thermostat

  1. Remove the cover and take out one battery.
  2. Press and hold , Keep holding while reinserting the battery.
  3. The screen will go blank after approximately 3 seconds.

Continue system setup in the App.

010205-Danfoss-Ally-Radiator-Thermostat-4

Documents / Resources

Danfoss 010205 Danfoss Ally Radiator Thermostat [pdf] User Guide
204986, 010205, Danfoss Ally Radiator Thermostat, 010205 Danfoss Ally Radiator Thermostat, AN31775663747302

References

Leave a comment

Your email address will not be published. Required fields are marked *