User Guide
Danfoss Icon2™ / 24V RT
Room Thermostat

Wake up the thermostat

Touch the screen – the actual room temperature is displayed (fig. A).
The Heating icon is displayed if the heat is on, and the Cooling icon is displayed if the cooling is on. The screen turns off after 10 seconds.

Set the temperature

Wake up the thermostat. Touch to set the temperature (temperature flashes to indicate setting in progress). Touch to confirm the new setting.

Open the Settings menu

Wake up the thermostat. Touch and hold to open the menu (fig. B).
Toggle the menu with, confirm with.
Touch to go backward in the menu.

Menus

: Temperature limitation, i.e. allowed setting range for room temperature.
: Product ID – your product can be identified with this code.
: Perform Link Test, if the thermostat has been moved. Check the signal, a result of 80 % or more equals a” strong connection”.
: Set min. and max. the temperature of the floor surface (the menu is only displayed if your thermostat has a floor sensor).
Note! Menus 4, 6, and 7 are only available to the installer.

BC29653691242001-000201 | VUMCA10F | 088N3691 www.icon.danfoss.com

Documents / Resources

	Danfoss VUMCA10F Room Thermostat [pdf] User Guide VUMCA10F Room Thermostat, VUMCA10F, Room Thermostat
	Danfoss VUMCA10F Room Thermostat [pdf] User Guide BC29653691242002-020301, VUMCA10F, 088N3691, VUMCA10F Room Thermostat, VUMCA10F, Room Thermostat, Thermostat

References

• User Manual