dahua logoM Series Monocular Upgrade Camera
User Guidedahua M Series Monocular Upgrade Camera

M Series Monocular Upgrade Camera

  1. Insert the SD card into the SD card slot of the monocular.dahua M Series Monocular Upgrade Camera - fig 1
  2. Turn on the monocular. The SD card icon will be displayed in the upper right corner of the screen. Press the menu button to enter the menu interface and select USB Mode as Mass.dahua M Series Monocular Upgrade Camera - fig 2
  3. Connect monocular with your computer via Micro USB cable. Copy the upgrade firmware into the SD card. After the copy is completed, unplug the data cable.
    Note: Make sure the firmware corresponds correctly. M20, M40, and M60 firmwares are incompatible with each other.
  4. Turn off the monocular.
  5. First press and hold the “Zoom” button, then press and hold the “Power” button at the same time.dahua M Series Monocular Upgrade Camera - fig 3
  6. When the “Dahua” logo appears on the screen, release your fingers.dahua M Series Monocular Upgrade Camera - fig 4
  7. It takes about 2-3 minutes for the device to automatically upgrade, and then the monocular will restart and enter the preview screen. At this point the upgrade is complete.dahua M Series Monocular Upgrade Camera - fig 5dahua logo

Documents / Resources

dahua M Series Monocular Upgrade Camera [pdf] User Guide
M Series, M Series Monocular Upgrade Camera, Monocular Upgrade Camera, Upgrade Camera, Camera
dahua M Series Monocular Upgrade [pdf] User Guide
M Series, Monocular Upgrade, M Series Monocular Upgrade

References

Leave a comment

Your email address will not be published. Required fields are marked *