CTA PAD-AALDS Angle Adjustable Locking Desktop Stand
Thank you
Thank you for choosing CTA Digital’s product. We hope that you will enjoy using it.
Please follow the guidelines and instructions as laid out in this instruction manual.
Package Contents
Instructions
Attaching Foam Pad to Tablet Holder
Select the appropriate foam pad according to the thickness of your tablet (or tablet in its case), then press adhesive side into center of the tablet holder.
Use this table to determine the appropriate foam pad to use with your tablet.
Note: sizes refer to total tablet size with or without a case.
| Foam Pad Thickness | Tablet Thickness: | |
| 1mm | 0.67-1.06in | / 17-27mm |
| 5mm | 0.51-0.91in | / 13-23mm |
| 10mm | 0.31-0.71in | / 8-18mm |
Mounting Your Stand
- Insert screw into hole on the stand base and use a Phillips head screwdriver to tighten.
- Repeat step 1 for all screws.
Installing Your Device
- Insert key and unlock the holder, take out the key, then slide the arm to open to a width according to your need.
- Insert key and lock the holder, take out the key, then insert your device corner first. Slide the arm back in until it is tightly gripping your tablet by the corners.
Adjusting your Tablet Holder:
Use Allen key to adjust tension at point of connection between the tablet holder and metal block.
Customer Support
Documents / Resources
 |
CTA PAD-AALDS Angle Adjustable Locking Desktop Stand [pdf] Instruction Manual PAD-AALDS Angle Adjustable Locking Desktop Stand, PAD-AALDS, Angle Adjustable Locking Desktop Stand, Adjustable Locking Desktop Stand, Locking Desktop Stand, Desktop Stand |
