CP Electronics EBDSPIR Ceiling Mounted PIR Presence Detectors
INSTALLATION INSTRUCTION
Basic switching, compact, IP40, ceiling, flush mounted, PIR, presence detector.
Warning
This device should be installed by a qualified electrician in accordance with the latest edition of the IEE wiring regulations
Downloads and Videos
Dimensions (mm)
Detection pattern
Wiring
Key
- Neutral
- Live
- 10A circuit protection if required
- Load
Installation
- This device is designed to be flush ceiling-mounted. See page 12 for additional mounting options.
- Do not site the unit where direct sunlight might enter the sensor.
- Do not site the sensor within 1m of any lighting, forced air heating, or ventilation.
- Do not fix the sensor to an unstable or vibrating surface.
Create cut out
Cut a 64mm diameter hole in the ceiling.
Wire stripping
- Strip the wires as shown opposite.
- The presence detector does not require an earth conductor
Wire in plugs & connect to the detector
Wire in plug/s, using the wiring diagram on page 3 as a guide. Connect the plug/s to the detector.
Clamp cable
Continue tightening the screws until the clamp bar snaps out and is tightly engaged against the cable/s. The cable clamp must clamp the outer sheath only.
Install detector 
- Bend the springs up and push the detector through a hole in the ceiling.
- When fully inserted the springs snap back to hold the device in place.
- To avoid injury, take care when bending springs.
Adjust settings using pots
Set up Lux & time out settings using pot adjustments, before fully installing into the ceiling cut out.
Testing
Presence Detection
- Power up the sensor. The load should come on immediately.
- Vacate the room or remain very still and wait for the load to switch off (this should take less than 20 minutes).
- Enter the room or make some movement and check that the load switches on.
Technical Data
Part code | EBDSPIR |
Weight | 0.150kg |
Supply voltage AC | 230 VAC +/- 10% |
Supply frequency | 50Hz |
Power consumption parasitic | 260mW |
Terminal capacity | 2.5mm² |
Max load: | |
Incandescent lighting | 8A |
Fluorescent lighting | 6A |
Compact fluorescent lighting | 3A |
LED lighting | 3A |
Resistive heaters | 8A |
Accessories
Part Number
- DBB: Surface mounting box
- DBB-EXT: Surface mount back box extender
- EBD-ENCIP1: Pre-drilled 64mm hole IP65 detector enclosure
- EXD-HSC: Extended wiring housing
- EBDSPIR-MS: Masking shields for EBDSPIR range
- CP Electronics
- Brent Crescent, London NW10 7XR
- t. +44 (0)333 900 0671
- enquiry@cpelectronics.co.uk
- www.cpelectronics.co.uk connect with us
- Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior notice.
Documents / Resources
![]() |
CP electronics EBDSPIR Ceiling Mounted PIR Presence Detectors [pdf] Installation Guide WD101, EBDSPIR Ceiling Mounted PIR Presence Detectors, EBDSPIR, Ceiling Mounted PIR Presence Detectors, PIR Presence Detectors, Presence Detectors, Detectors |