CORSTON Small Wall Light
Specifications
- Product: Small wall light
- Dimensions: Refer to page 4 of the manual for exact measurements
- Components: Light body x1, Wall mount x1, Wall screw x3, Anchor x3, 2-terminal WAGO x3, Hex key x1, Drill 6mm drill bit, Crosshead screwdriver
- Installation: Suitable for wet and dry environments, IP rated
INCLUDED
TOOLS YOU’LL NEED
Product Usage Instructions
- Install the wall light mount. See for dimensions
- Push wires through the grommet.
- Connect the WAGOs inside the base.
- Tighten the grub screws.
- Unscrew the glass cover to add the bulb.
Note: the glass cover protects the bulb in wet environments and is required for the IP rating. If the light is installed in a dry setting, you can remove the glass cover to increase the life expectancy of the bulb. - Claremont: screw the shade onto the body.
- Malvern: use the shade ring to secure the shade.
- Richmond (hanging): use the grub screw to adjust the shade height.
- Malvern: use the shade ring to secure the shade.
hi@corston.eu
+44 (0)1249 549332
FAQs
Can I install this light fixture in a wet environment?
Yes, the light is suitable for wet environments and is IP rated for protection.
Do I need to keep the glass cover on the light?
The glass cover is necessary for wet environments to protect the bulb. In dry settings, you can remove it to increase bulb life.
Documents / Resources
 | Small Wall Light |
References
- User Manualmanual.tools
Published: September 24, 2025