Coolo Zigbee Smart Light Sensor
Network Configuration
- Power on the product
- Align the opener to the slot
- Anticlockwise rotate the battery cover to open
- Remove the battery insulation film to power
- Align the opener to the slot
- Press the RESET button for 3s and release, the red LED will flash for network configuration.
Installation Instructions
Installation position
Remove the protective film from the adhesive on the base. Stick the device where needed as shown in the following figure.
Please read the manual carefully and use the product correctly
Thank you for purchasing and using this product. Before using the product, please read the manual carefully and use the product correctly. In order to avoid damage to the equipment, such as all consequences caused by abnormal operation, the company will not bear any responsibility. The pictures in this manual are used to guide the user’s operation and are for reference only. Please refer to the actual product for details.
Product description
Tips:
This product must be connected to the Zigbee gateway to function properly and upload data to the server/APP
Product Parameters
- Product Name Zigbee Ambient Light Sensor
- Wireless Protocol Zigbee 3.0
- Detection Range 0~157K Lux
- Battery TypeCR2450
- Standby Current<10uA
- Working Temperature -10 ~ 55 C
- Working Humidity 0% ~ 95%RH
- Product Size Ф 33×16mm
Documents / Resources
 |
coolo Zigbee Smart Light Sensor [pdf] User Manual Sd0a55e3314af4bb7a3a8b1405027227de, Zigbee Smart Light Sensor, Smart Light Sensor, Light Sensor |