CONDUCTIX wampfler 08-S265-2346-002 Conductor Bar in EMS-Systems

NOTE!
BMW stipulates a plate with a cable guide 08-P025-0191-001. This plate must be con-sidered for new installations and rebuilding. It allows the obeying of the correct installa-tion dimensions and a safe cable guide.
For EMS applications which are not used for BMW we also recommend to retrofit the plate according to the distance dimension of 75 mm.

Installation Instructions

Conductor Bar in EMS-Systems
Collector Unit

Polarity Protection
BMW Best Practice solution as shown in BMW specification

Copper-graphite Brushes compared to pure graphite Brushes

Replace copper-graphite Collectors with pure graphite Collectors

1. Old copper- graphite collector height (when en-gaged): 80 mm (due to brush head with 10 mm height). New pure graphite collector height (when engaged): 75 mm (due to brush head with 5 mm height) Plate 5 mm must be used
2. Collector adjustment: Exact center line of copper rail and brush head to be kept

Mistakes to avoid

1. Cables are not installed correctly:
   • No parallel cable guide
     
   • Cable bundle creates force on collector heads
     
   • Collector heads are not running parallel to conductor rail
2. Collector adjustment: Brush head not aligned properly (too high!) = Brush head runs permanently in an angle and grinds the plastic isolation of the conductor rail.

Recommendations

• When EMS trolley doors are dismantled (for collector changes) make sure that all doors are marked with num-bers (same as trolley numbers) to ensure that combination of doors and trolleys are kept.
• Check all collector support brackets (“Z”-bracket) for exact angles and parallel surface to trolley door and con-ductor rails.
• Check exact position of door hinges.
• Use proven Conductix-Wampfler high flexible cables.
• Do not bundle cables or use cable marker (negative influence of the collector).
• Check existing brush wear sensor unit (new set up needed).
• Make sure that all PEplus end caps of the conductor rails are green (indication for PEplus system).

Conductix-Wampfler GmbH Rheinstraße 27 + 33 79576 Weil am Rhein – Märkt Germany
Importer for the United Kingdom: Conductix-Wampfler Ltd.
1, Michigan Avenue
Salford
M50 2GY
United Kingdom
Phone: +49 (0) 7621 662-0
Fax: +49 (0) 7621 662-144
info.de@conductix.com
www.conductix.com
Phone: +44 161 8480161
Fax: +44 161 8737017
info.uk@conductix.com www.conductix.com

Documents / Resources

CONDUCTIX wampfler 08-S265-2346-002 Conductor Bar in EMS-Systems [pdf] Instruction Manual 08-S265-2346-002, 08-S265-2345-002, 08-P025-0191-001, 08-P025-0192-001, 08-S265-2346-002 Conductor Bar in EMS-Systems, 08-S265-2346-002, Conductor Bar in EMS-Systems, Conductor Bar, Bar

References

• User Manual