COMREX MAX-M Peplink Pepwave MAX Adapter

COMREX MAX-M Peplink Pepwave MAX Adapter

Attaching the Modem(s)

  1. Locate the Mounting Posts: The modem bracket contains two pairs of mounting posts, one vertical pair facing down toward the ACCESS NX and one horizontal, pair facing up away from the unit.
    Attaching the Modem(s)
  2. Locate the Screw Holes: The Pepwove MAX Adapter contains four screw holes on the “underside”, where the model label con be found. One pair of these holes will align with the mounting posts on the bracket.
    Attaching the Modem(s)
  3. Align the Modem: Align the correct screw holes with one set of mounting posts on the modem bracket and attach the modem by tightening the screws from the other side of the bracket.
    Attaching the Modem(s)
  4. Align a 2nd Modem: To attach a second modem, repeat the process using tl,e remaining set of mounting posts.
    Attaching the Modem(s)

    Installing the Bracket

  5. Locate the Mounting Screws: The ACCESS NX Portable comes equipped with two accessory-mounting screws, located on the “top” metal plate, where the A/C power and Ethernet jacks can be found.
    Installing the Bracket
  6. Secure the Bracket In Place: Remove the two screws and use them to attach the modem bracket to the ACCESS NX Portable. The bracket’s longest side should rise “forward”, past the LCD touchscreen.
    Installing the Bracket

    Connect via USB

  7. Identify the Left and Right USB Cables: The modem bracket comes with two different USB cables. One cable is oriented toward the ACCESS NX’s ‘Right’ USB port, and the other is oriented for the ‘Left’ USB port.
    Connect via USB
  8. Connect the Cable(s): Connect the smaller USB-C side into the Pepwave MAX Adapter, then connect the larger USB A side into the appropriate USB port on the ACCESS NX Portable.
    Connect via USB

    Enable in Network Manager

  9. Open the Network Manager: Open the ACCESS NX Portable’s Network Manager by pressing the 3-line menu button in the upper left corner of the touchscreen and choosing “Network Manager”.
    Enable in Network Manager
  10. Enable the Installed Modem(s): Find the Pepwave MAX Adapter in the network device list on the left side of the screen and select it to open more details on the right side. Ensure that the modem is listed as “Installed and enabled”. Tap the “Enable” button below if needed.
    Enable in Network Manager

CUSTOMER SUPPORT

Toll Free in USA: 800-237-1776_ www.comrex.com
e-mail: info@comrex.com
19 Pine Road, Devens, MA 01434 USA
Tel: +1·978-784-1776Fax: +1-978-784-1717
Logo

Documents / Resources

COMREX MAX-M Peplink Pepwave MAX Adapter [pdf] User Manual
MAX-M Peplink Pepwave MAX Adapter, MAX-M, Peplink Pepwave MAX Adapter, MAX Adapter, Adapter

References

Leave a comment

Your email address will not be published. Required fields are marked *