COLOP e-mark Create User Manual
QUICK SET UP GUIDE
For complete instructions visit: emarkcreate.colop.com/support
PRINTING AT A GLANCE
- In the app select New Imprint from the drop down menu.
- Choose Start Without Template or select a pre-made template from your preferred category.
- Arrange or edit your artwork on the canvas.
- Once your design is ready to go select the e-mark® create icon in the top right corner.
- The e-mark® create will beep & the app will indicate when your print has been received.
- Simply swipe e-mark® create to print your design.
MENU GUIDE
- Print your design
- Connect your e-mark® create check battery & ink levels
- Choose a customizable template or design your own.
- View, edit or print a previous design.
Updated preferences, clean print head, & more. - Web instructions, order ink cartridges, & more
IMPRINT SETTINGS
- Choose between single line or multi-line canvas.
- Adjust the width of your canvas.
- Turn continual printing on or off.
MULTI-LINE PRINTING
- Choose either two or three line printing option.
- Once your design is ready to go select the e-mark® create icon in the top right corner.
- The e-mark® create will beep & the app will indicate when your print has been received.
- Follow the chart above to print each line. The e-mark® create will beep to indicate when you should change direction.
CONTINUAL PRINTING
- Make sure continual marking is turned on in imprint settings.
- Once your design is ready to go select the e-mark® create icon in the top right corner.
- The e-mark® create will beep & the app will indicate when your print has been received.
- Swipe e-mark® create to print your design. The e-mark® create will continue to print as long as it is in motion.
AUTOMATIC CLEANING CYCLE
The e-mark® create cleans its print head automatically whenever it is taken from the docking station. The intensity of cleaning increases the longer the e-mark®
create is not used.
- Take e-mark® create from docking station.
- Hold briefly in the air (wait for ink to disperse).
- Put on Paper & print.
Do not point towards the eyes, face, or skin. Do not point towards docking station or towards the print surface during the cleaning cycle.
LIGHT GUIDE
Read More About This User Manuals…
COLOP-e-mark-Create-Manual-Optimized.pdf
COLOP-e-mark-Create-Manual-Orginal.pdf
Questions about your Manual? Post in the comments!
References
- User Manualmanual.tools
Published: December 14, 2020
Hello I have you and so I do not have the password of your ssid
The device was delivered about three months ago
Bonjour je n’ai toi et je n’ai donc pas le mot de passe de votre ssid
L’appareil a été livré il y a environ trois mois
The device was delivered about three months ago</strong></em>
Bonjour je n'ai toi et je n'ai donc pas le mot de passe de votre ssid
L'appareil a été livré il y a environ trois mois
What is the default Wi-Fi SSID password for the COLOP e-mark Create?
To connect your COLOP e-mark Create to your mobile device or PC via Wi-Fi, you will need the unique SSID and password for your specific unit. This information is typically found on a label provided with the device.
Please check the following locations for your password:
The default password is typically a string of characters unique to your serial number. If you have lost the sticker and cannot find it inside the cover, you may need to contact COLOP support with your device's serial number for recovery.
Read the full Q&A page