COASTER 107451 Dining Table Installation Guide

COASTER 107451 Dining Table

Overview

Coaster Fine Furniture dining table (Item: 107451) is intended for home use. Assemble by following the numbered instructions in order for fast and easy assembly, and verify that all hardware and parts are present before starting.

Product Specifications

Quick Assembly Guide

1. Remove hardware from the box and sort by size. Confirm all parts and hardware are present.
2. Step 1: Attach mounting plates (D) to leg frames (C) using short bolts (3), lock washers (4), and flat washers (5). Tighten with the provided Allen wrench (6).
3. Step 2: Connect the two leg frames (C) with the crossbar (E) using long bolts (1), lock washers (4), and flat washers (5). Tighten with the Allen wrench (6).
4. Step 3: Begin attaching the table top assembly to the secured base frame.
5. Step 4: Secure the table top structure completely to the base using the hardware provided.
6. Step 5: Install and align table top sections (A) and the table leaf (B). Position the leaf between the table top halves so the support rails match.
7. Step 6: Secure the table leaf and top sections using the integrated latch mechanisms underneath. Fasten latches to the CLOSED position to lock the pieces together.

Tool note: A Phillips head screwdriver is required, but it is not provided.

ASSEMBLY TIPS

1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.

WARNING!

1. Don’t attempt to repair or modify parts that are broken or defective. Please contact the store immediately.
2. This product is for home use only and not intended for commercial establishments.

PARTS IDENTIFICATION

HARDWARE IDENTIFICATION

NOTE: Phillips head screw driver is required in the assembly process; however, manufacturer does not provide this item.

Installation

Dimension

Troubleshooting

• Missing hardware or parts: Before starting assembly, check that all hardware and parts are present.
• Hardware won’t tighten securely: Use the provided Allen wrench for bolts at the mounting plate and crossbar connections, following the numbered sequence and tightening steps as written.
• Table pieces won’t stay locked: Ensure the integrated latch mechanisms underneath are fastened to the CLOSED position to lock the table leaf and top sections firmly together.
• Broken or defective parts: Do not attempt to repair or modify broken/defective parts—contact the store immediately.