PXN A3

Connection

For PXN Racing Wheels

1. Plug the Pedals into the pedals' port on the racing wheel using the registered jack connector cable.
2. The Pedals red indicator will remain ON when the connection is successful, and the Pedals can be used.

Diagram description: Shows pedals connecting to a racing wheel via a registered jack connector cable. A red indicator light is shown on the pedals.

For PC

1. Plug the Pedals into a PC USB port with the USB to USB-B cable.
2. The Pedals red indicator will remain ON when the connection is successful, and the Pedals can be used.

Diagram description: Shows pedals connecting to a PC via a USB-A to USB-B cable. A red indicator light is shown on the pedals.

Axis Correspondence

The value axis of the Pedals correspond to clutch (X-axis), brake (Z-axis), and accelerator (Y-axis).

Note: In games of the D-input category, the games will recognize both the racing wheel and pedals separately. The pedals can be used by setting them within the game.

Installation

The Pedals Angle Adjustment

1. Loosen the two Allen key screws using the provided Allen wrench.
2. Adjust the Pedals to the desired position and tighten the two Allen key screws.

Diagram description: Illustrates the pedal angle adjustment: one image shows loosening two Allen key screws with an Allen wrench, another shows adjusting the pedal position, and a third shows tightening the screws.

The Pedals Strength Adjustment

Rotate the component as shown to adjust the Foot Pedals' strength.

Note: Please do not over-tighten. Rotate the component within the screw thread.

Diagram description: Shows a component on the pedals that can be rotated to adjust the foot pedal strength. A note indicates not to over-tighten and to rotate within the screw thread.

Clamp the Pedals

There are 4 dedicated screw holes for clamping the racing wheel on a stand using the included screws.

Diagram description: Shows the underside of the pedals with four dedicated screw holes for clamping onto a stand. Dimensions are also indicated: 96 mm, 220 mm, 97 mm, 53.6 mm, 235 mm.

Product Accessories

• USB to USB-B cable
• Registered Jack Connector Cable
• Allen key screw (x4)
• Allen wrench (x1)

Supported Platforms

• Support Windows 7/8/10/11
• PXN Racing Wheels: PXN-V10

Product Specifications

Attention

• Avoid strong vibration and gravity dropping.
• Do not disassemble, modify, or repair by yourself.
• Prevent water or other liquids from entering the product to avoid damage.
• Avoid storing in humid, high temperature, oily smoke, and other places.
• Please handle it gently when connecting and removing the product.
• Children should be under adult supervision at all times when using this product.