DVC DF7, DF7-W 2 Wire Intercom System
Mga bahin ug gimbuhaton
Pakigsulti/Pag-monitor
I-scroll down
Unlock
Amang
Pag-scroll pataas
Divert
Talk voice volume switch: ang volume sa speaker voice kung makigsulti sa door station, pataas nagpasabut nga taas, ubos nagpasabut nga ubos.
Mga koneksyon
PAHIBALO: the DF7monitor does not support DT-IPG, RLC light mode requires update RLC to support.
DF7 monitors does not support in-out connection.
Pagbutang
Pag-setup sa Pag-install
Pag-setup sa adres
DIP Switcher Set Address
The DIP switches are used to set the user code for each monitor. Total 6 bits can be configured.
- Bit-1 to Bit-5 are used for user code setting. The value range is from 0 to 31, which have 32 different codes for 32 apartments.
- When multi monitors need to be installed in one apartment, these monitors should use the same user code, and the master/slave mode should be set on the monitor. (Details refer to the section of Setting Slave Monitor)
- Bit-6 is bus line terminal switch, which should be set to “ON” if the monitor is at the end of bus line, otherwise be set to “OFF”.
Bit-6 switch setting
Master/Slave setup
By monitor menu Refer address setup step 1
- Tapik
to get into main menu
- In main menu, long press unlock key
- Tapik
to set monitor master slave
Auto call back
- After 1 and 2 setups, DF7 can apply a calling from DF7, simulator a call from door station.
- When power up and standby (DF7 is screen off), press and hold 3s until
mga pangidlap.
Pag-setup sa personalization sa user
- Adjust ringtone volume
- levels adjustable. When standby, into main menu, tap
nagtumong
to switch the volume between large and small.
Change ringtone melody
3 sets of the ring tune selectable. When standby, into main menu, tap (refers
)to switch the melody between 3 sets, after switch DF7 will play the melody for door station calling, inner call, and ring button separately.
Operasyon
Status setup (Do Not Disturb)
When power up and standby (DF7 is screen off), :
- Tapik
to enable “Do Not Disturb”, the corresponding LED solid on mean the is in Do Not Disturb and will not ring for any calls.
- Tapik
to enable/disable “Divert to APP”. (*Reserve function, requires additional accessary or specific door station to enable, not working for 2easy standard door station.)
Accept calling
When DF7 rings,
- Tapik
to accept calling.
- Tapik
(refers
) to release door lock 1.
- Tapik
(refers
) to release door lock2.
- Tapik
(refers
) to adjust brightness of the image, 2 levels.
- Tapik
(refers
) to switch to other door station camera(if has).
Monitor door station
When power up and standby (DF7 is screen off), or in main menu, tap to start monitoring door station 1.
In monitoring check “Operation, point 2) for operations.
Intercom call / Inner call
When power up and standby (DF7 is screen off), into operate menu, tap refer
to get into intercom/inner call menu.
And use ug
to scroll to the address needs to call and tap
to call, tap
again to end calling.
- GU: to Guard Unit.
- SA sulod: to monitor with the same address.
Operating the light thought DT-RLC/Mini RLC
When power up and standby (DF7 is screen off), into main menu, tap refer
to light up RLC’s light. When the icon turns in yellow means light up
PAHIBALO: limit support on DT-RLC(with only DT607/608/821,DMR18S)
Ibalik ang Setting sa Pabrika
To restore to the factory default settings, by following steps.
- .Disconnect the DF7 from bus line, wait for 30s, and connect to bus line.
- Within 10s power up, press and hold
for 12s, release when and LED flashes.
- A long beep means all setting rest to factory default
Ang adres magpabilin samtang ang agalon/ulipon iuli
Panagana
- Ang tanan nga mga sangkap kinahanglan mapanalipdan gikan sa pagkurog sa kapintasan. Ug dili tugotan nga maapektuhan, matumba ug matumba.
- Please do the cleanness with soft cotton cloth, please do not use the organic impregnant or chemical clean agent. If necessary, please use a little pure water or dilute soap water to clean the dust.
- Mahimong mahitabo ang pagtuis sa imahe kung ang monitor sa video gi-mount nga duol kaayo sa magnetic field eg Microwaves, TV, kompyuter ug uban pa.
- Please keep away the monitor from wet, high temperature, dust, caustic and oxidation gas in order to avoid any unpredictable damage.
- Kinahanglan nga mogamit sa husto nga adapter nga gihatag sa tiggama o gi-aprubahan sa tiggama.
- Hatagi'g pagtagad ang taas nga voltage sa sulod sa mga produkto, palihug i-refer ang serbisyo sa usa ka nabansay ug kwalipikado nga propesyonal.
Espesipikasyon
Power Supply: DC20 ~28 V
- Pagkonsumo sa kuryente : standby 9mA,working 127mA
- Temperatura sa Pagtrabaho : -15ºC ~ +55ºC
- Wiring: 2 ka wire, non-polarity
- Monitor screen: 7 Inch digital color LCD
- Operation Dimension:
- DF7 : 186.2*139.2*13.8mm(not include the metal support)
Ang disenyo ug mga detalye mahimong mausab nga walay pahibalo sa tiggamit. Ang katungod sa paghubad ug copyright niini nga manwal gipreserbar.
Mga FAQ
- P: Mahimo bang gamiton ang monitor sa DF7 sa mga standard nga istasyon sa pultahan?
- A: Yes, the DF7 monitor is compatible with standard door stations, but certain functions may require additional accessories or specific door stations for full functionality.
- P: Pila ka mga user code ang ma-set up sa DF7 system?
- A: The system supports up to 32 different user codes for individual apartments or units.
- P: Giunsa paggamit ang auto call back feature sa DF7 system?
- A: After setting up the address and master/slave configurations, initiate a call from the DF7 by pressing and holding a specific button until prompted to release. This simulates a call from the door station.
Mga Dokumento / Mga Kapanguhaan
![]() |
DVC DF7, DF7-W 2 Wire Intercom System [pdf] Manwal sa Gumagamit DF7, DF7-W, DF7 DF7-W 2 Wire Intercom System, DF7 DF7-W, 2 Wire Intercom System, Intercom System, System |