FLYWING manufactures high-performance GPS-stabilized RC helicopters and flight controllers, offering realistic scale models and beginner-friendly flight technology.
FLYWING is a specialized manufacturer of radio-controlled (RC) helicopters and advanced flight control systems. Bridging the gap between toy drones and professional hobby-grade aircraft, FLYWING is known for producing detailed scale replicas—such as the UH-1D Huey and Bell 412—alongside high-performance 3D aerobatic models like the FW450L.
The brand distinguishes itself by integrating modern drone technology into rotary-wing aircraft. Features often include GPS intelligent flight modes, optical flow positioning, altitude hold, and one-key return functions, making the complex art of flying RC helicopters accessible to beginners. For advanced pilots, FLYWING provides the H1 and H2 flight controllers, which support fully manual 3D flight and extensive software customization.
Latest manuals from manuals+ curated for this brand.
Watch setup, installation, and troubleshooting videos for this brand.
Common questions about manuals, registration, and support for this brand.
To arm the motors, typically perform an inverted V stick movement (move both sticks to the bottom outer corners) on the transmitter. Ensure the helicopter is on a level surface and GPS lock is established if using GPS mode.
A slow red flash usually indicates a low battery warning, advising you to fly within visual range. A rapid red flash indicates a critical battery level, and the aircraft may initiate an automatic landing to prevent damage.
Vibration on takeoff is often caused by loose rotor blades. Use the included tool to tighten the propeller screws until the blades do not sag when the helicopter is held sideways.
Use the assigned flight mode switch on your transmitter (often Channel 5). A solid green light on the flight controller typically indicates GPS/Stabilized mode, while a solid red light indicates Manual/3D mode.
After the helicopter has landed, pull the throttle stick to the lowest position and hold it for more than 3 seconds, or use the designated motor disarm switch if configured.