April 12, 2026
FD HSE1 868MHz Garage Door Opener INSTRUCTION LEARNING CODE: ➤ 1.Pressing the button of remote control, which you are going to store the code from original remote, keep it pressed, pressing one of any other buttons 3 times, until the LED is illuminated red for 10s, release all of buttons. ➤ 2.Placing the original remote on the left of remote, as close as possible. ➤ 3. Pressing the button of original remote control, which you are going to copy code, until the led alternates flashing in red and blue, check if the LED of remote flashing in blue, if no, try to take it more close to the original remote. ➤ 4.The learning procedure will be finished when the remote fast flash in blue, release all of buttons. ➤ 5. Pls do the same procedure for the rest of buttons. RESET: Each button of remote control is assigned to a new radio code by means of the following steps. ➤ 1. Removing the battery for 10s ➤ 2. Pressing one button of remote control and keep it pressed ➤ 3. Inserting the battery, The LED slowly flashes in blue for 4s,…