CARBEST 465116 Autolift System Instruction Manual
ATTENTION:
THE MOTOR JACK SHOULD BE FACING THE CENTER OF THE VEHICLE, WHILE ROTATING TOWARDS THE BACK.
Rear adapter Ducato X250 (REAR VAN)
ATTENTION:
THE MINIMUM MEASURE REQUIRED FOR THE INSTALLATION FOR THE SPECIFIC ADAPTER FOR DUCATO VAN:
41 CENTIMETER FROM THE TOWING EYE WELDING SPOT TO THE GROUND IN THE POINT INDICATED.
STEP 1:
The rear adapters must be placed behind the rear axle, at the outer rim of the chassis. Insert the sealing plates in the point shown below. Subsequently fix the sealing plate with 2 10 x 30 mm screws.
STEP 2:
Fix the adapter using the 2 10 x 140 mm bolts, subsequently fix the jacks.
ATTENTION:
BOTH REAR MOTOR JACKS SHOULD BE FACING THE OUTSIDE OF THE VEHICLE, WHILE ROTATING TOWARDS THE BACK.
REIMO REISEMOBIL-CENTER GMBH
63329 EGELSBACH · BOSCHRING 10 · GERMANY· WWW.REIMO.COM
MADE IN ITALY, ©REIMO 06/2022
Documents / Resources
 |
CARBEST 465116 Autolift System [pdf] Instruction Manual 465116 Autolift System, 465116, Autolift System, System |