CAME TFM 2 and 4 Channel Transmitters

Product Information

Specifications

• Transmitter Channels: 2/4/8
• Coding: 20-bit code and 4-bit channel code

Product Usage Instructions

Coding of 2/4 Channel Transmitters

1. Fit the jumper to the transmitter strip (pos. A).
2. Press the key to be coded.
3. In sequence, press P1 (ON) and P2 (OFF) to memorise the 20-bit code and then the 4-bit channel code (refer to EXAMPLE).
4. Remove the jumper (pos. B).
5. Repeat steps 1 to 4 for each key.

Coding of 8 Channel Transmitters

1. Follow the same procedure as for the 4-channel setting (avoid using channels 13, 14, 15, and 16).
2. Ensure that the selector switch on the left edge is positioned correctly.
3. For keys P5, P6, P7, and P8, they are coded automatically (refer to example and table C).
4. To activate these keys, move the selector to the position shown in Figure B.

OVERVIEW

coding of the 2/4 CHANNEL transmitter

1. Fit the jumper to the transmitter strip (pos. A);
2. Press the key to be coded.
3. In sequence, press P1 (ON) and P2 (OFF) to memorise the 20-bit code and then the 4-bit channel code (see EXAMPLE);
4. Remove the jumper (pos. B).
   • Repeat steps 1) to 4) for each key.

KEYPRESS SEQUENCE TO CODE

EXAMPLE: KEYPRESS SEQUENCE TO CODE P3 KEY ON 4 CHANNEL TRANSMITTER

• IMPORTANT! In order to facilitate and store the coding procedure for the transmitters, mark the settings on the 4 diagrams shown opposite (choose the channel settings from those in the table below).

CHANNELS TABLE

FIRST SET OF KEYS

• FIRST SET OF KEYS (P1/2/3/4) – Carefully follow the procedure used for the 4-channel setting (ATTENTION! DO NOT USE CHANNELS 13,14,15, AND 16).
• Ensure that the selector switch on the left edge is positioned as shown in Figure A.
• SECOND SET OF KEYS (P5/6/7/8) – These keys are coded automatically (see example and table C ); to activate these keys, move the selector to the position shown in figure B

EXAMPLE

If key P1 has been associated with the combination of code X and channel 2, key P5 will automatically be associated with the combination of code X and channel 16.

TABLE: C

TECHNICAL SPECIFICATIONS

• POWER SUPPLY:
  • 12V d.c. battery
• RANGE:
  • from 50 to 200 metres
• SIGNALLING:
  • audible signal of an actuated system
• COMBINATIONS:
  • up to 16,777,216; each key can be assigned a personal, independent code and operating channel
• CABINET:
  • material: ABS
  • dimensions: 45x92x15 mm
  • weight: 51 grams

FAQ

How do I know which channels to select from the table?

To select channels, refer to the CHANNELS TABLE provided in the manual and mark the settings on the diagrams accordingly.

Documents / Resources

CAME TFM 2 and 4 Channel Transmitters [pdf] Instruction Manual TFM 2 and 4 Channel Transmitters, 2 and 4 Channel Transmitters, Transmitters

References

• User Manual