Lazerpoint™ RX-DB
Installation Instructions
RX-DB Lazer Point
STEP 1
– Ensure power is turned off, or removed from board
– Carefully press in two tabs on one end of plastic case
– Pry case lid up and off circuit board. Set aside
STEP 2
– Remove daughterboard from packaging, and carefully insert it into either one of the two headers on main circuit board
– Ensure all 9 pins are properly seated into header, and daughterboard is straight up and down (not bent over)
STEP3
– Repeat for additional daughterboard, if desired
– Using case lid as a guide carefully route antenna wires to fit into slots on lid
– Re-install lid making sure wires are routed to avoid damage
– lid should snap onto tabs on ends
CAUTION !
Do not install or remove
Daughterboard(s) with unit powered.
Remove power first
| Camden Door Controls 5502 Timberlea Blvd. Mississauga, Ontario L4W 217 |
|||
| SCALE: NONE | DRAWN BY: DGW | DATE: 03/24/10 | REVISED: 16/09/15 |
| RX-DB Daughterboard Assembly | |||
| DRAWING No: DRG-RX-DB | FILENAME: Daughterboard Assembly Diagram Ver_1_01.vsd |
||
www.camdencontrols.com
Toll Free: 1.877.226.3369
Made in Canada
File: Lazerpoint™ RX-DB Instructions.doc Rev1
Revision: 16/09/2015
Part No.: 40-82B123
5502 Timberlea Blvd.,
Mississauga, ON Canada
L4W 2T7
Certified ISO 9001: 2008
Documents / Resources
 |
CAMDEN DOOR CONTROLS RX-DB Lazer Point [pdf] Installation Guide 01, 40-82B123, RX-DB, RX-DB Lazer Point, Lazer Point, Point |
