CALIMET CM9-975B Vehicle Exit Wand
Specifications
- Model: CM9-975B Vehicle Exit Wand
- Installation: Ground Level, New Concrete Sealer, Electrical Conduit
- Wire Connection Diagram: Exit Wand Wire Connection Diagram
- Power Supply: 24V-DC
- Color Coding: Open/Loop (Y), 24V-DC (R), 24V-COM (B)
Product Usage Instructions
Installation
- Ensure the installation location is at ground level and has a new concrete sealer.
- Run the electrical conduit to the designated power source.
- Refer to the Exit Wand Wire Connection Diagram for proper wire connections.
Operation
- Ensure the power supply is 24V-DC.
- Connect the wires following the color coding: Open/Loop (Y), 24V-DC (R), 24V-COM (B).
- Secure connections to ensure a snug fit.
CM9-975B VEHICLE EXIT WAND
Exit Wand Installation
- On your concrete drive-way, use a 1 inch concrete bit and drill a 5 inch deep at the desired position.
- Cut a straight line 1 inch deep and 3/16 inch width from the exit wand to the motor.
- Install the exit wand in the hole and make sure it is snug fit to the bottom. You should have 1.75” to the ground level.
- Install the exit wand wire (we recommend using electric conduit to extends the cable life).
- Follow the wiring diagram and connect while main power is OFF.
Exit Wand Wire Connection Diagram
CM9-975B USER MANUAL
FAQS
Q: What should I do if the wand is not detecting vehicles?
A: Check the power supply connection and ensure the wires are properly connected following the wire connection diagram.
Q: Can the exit wand be installed on any surface?
A: It is recommended to install the exit wand on a ground level surface with a new concrete sealer for optimal performance.
Documents / Resources
 |
CALIMET CM9-975B Vehicle Exit Wand [pdf] Instructions CM9-975B Vehicle Exit Wand, CM9-975B, Vehicle Exit Wand, Exit Wand, Wand |