Instructions for CALIMET models including: CM9-975B Vehicle Exit Wand, CM9-975B, Vehicle Exit Wand, Exit Wand, Wand
CM9-975B VEHICLE EXIT WAND CM9-975B USER MANUAL V.01.01282025 Exit Wand Installation 1. On your concrete drive-way, use a 1 inch concrete bit and drill a 5 inch deep at the desired position.
CM9-975B VEHICLE EXIT WAND Exit Wand Installation 1. On your concrete drive-way, use a 1 inch concrete bit and drill a 5 inch deep at the desired position. 2. Cut a straight line 1 inch deep and 3/16 inch width from the exit wand to the motor. 3. Install the exit wand in the hole and make sure it is snug fit to the bottom. You should have 1.75" to the ground level. 4. Install the exit wand wire (we recommend using electric conduit to extends the cable life). 5. Follow the wiring diagram and connect while main power is OFF. GROUND LEVEL NEW CONCRETE SEALER ELECTRICAL CONDUIT Exit Wand Wire Connection Diagram CLOSE PED-SW SAFETY PHANTOM OPEN/LOOP 24V-DC 24V-COM OUT IN OUT IN OPEN/LOOP (Y) 24V-DC (R) 24V-COM (B) SNUG FIT CM9-975B USER MANUAL V.01.01282025Adobe PDF library 17.00 Adobe Illustrator(R) 24.0