INSTALLATION INSTRUCTION
N-F77CVR CONCEALED VERTICAL ROD
EXIT DEVICE
N-77CVR Concealed Vertical Rod Exit Device
TO CHANGE BOTTOM LATCH FOR BOTTOM STRIKE
| 1.Device factory pre-set. | 2-1.Unscrew and remove screw and L-shaped bracket. 2-2. The L-shaped bracket moves backward. 2-1.Unscrew and remove screw and L-shaped bracket. 2-2. The L-shaped bracket moves backward. |
2-1.Unscrew and remove screw and L-shaped bracket. 2-2. The L-shaped bracket moves backward. | 4. Change Done. |
 |
 |
 |
 |
INSTALL INNER CHASSIS & TOP LATCH
INSTALL BOTTOM LATCH
(Skip this step if less Bottom Rod)
INSTALL TOP & BOTTOMSTRIKE
(Please Follow TEMPLATE)
TO CHANGE HAND OF N-F77CVR EXIT DEVICE
| 1. LHR | 2-1. Remove chassis pin & main slide & tube. 2-2. Remove lift lever & lift lever pin. 2-3. Rotate 180° main slide & lift lever |
 |
 |
| 3-1. Reassemble lift lever at opposite side, as shown. 3-2. Replace main slide and chassis pin and lift lever pin. and fixed screw. |
1. RHR Done. |
 |
 |
Documents / Resources
 |
CAL-ROYAL N-77CVR Concealed Vertical Rod Exit Device [pdf] Instruction Manual N-77CVR Concealed Vertical Rod Exit Device, N-77CVR, Concealed Vertical Rod Exit Device, Rod Exit Device, Device |
 |
CAL-ROYAL N-77CVR Concealed Vertical Rod Exit Device [pdf] Instruction Manual N-77CVR Concealed Vertical Rod Exit Device, N-77CVR, Concealed Vertical Rod Exit Device, Vertical Rod Exit Device, Rod Exit Device, Exit Device |
