150 Pull-Out Base Unit Assembly
TH Note: If fitting a “True Handleless” kitchen, some components will differ to those shown in this instruction and will also be packaged separately. Please refer to your True Handleless guide to Receiving for further details on the different components and difference in installation.
Components
Important Information – True Handleless Kitchens Installers: See Note Above TH
Caution: Some pieces of hardware could be hazardous to small children. Keep all these items out of reach and do not leave children unattended in the assembly area. Please read these instructions carefully before proceeding. Refer to the Guide to Receiving and Installing your Kitchen booklet for further information. Note: Due to variation in wall conditions no screws are supplied for fixing the units to the wall. If in doubt consult an expert. Assemble the unit on a clean solid work surface. In the interest of continuing improvements we reserve the right to amend or adjust the specifications without prior notice. Errors and omissions excepted. This unit is fitted with a wirework system. The wirework is supplied separately. These instructions advise when to fit parts of the wirework system. Follow the instructions supplied with the wirework for wirework assembly. Every effort has been made to ensure that this product leaves the factory in perfect condition. In the unlikely event that an item is damaged or incorrect, please contact the customer services department.
Note – Fitting Handles: (1) Decide where you are going to position each handle to maintain symmetry around your kitchen. (2) Measure the handle centres and mark off each door/drawer position. (3) Drill through the door/drawer using a fine drill (<2.5mm), then drill back from the rear face using a 4.5mm drill. (4) Attach with the fixings provided with your handle.
| Ref. No. | Item | Quantity |
| 150101 |  |
4 |
| 150202 |  |
4 |
| 150201 |  |
16 |
| 150199 |  |
2 |
| 154082 |  |
8 |
| 154085 |  |
8 |
| 154004 |  |
8 |
| 150308 |  |
2 |
| 150309 |  |
2 |
| 154047 |  |
2 |
| 151500 |  |
2 |
| 151999 |  |
4 |
| 152401 |  |
4 |
| 152418 |  |
4 |
| 152402 |  |
2 |
| Note: These are supplied with the wirework. | ||
 |
6 | |
 |
8 | |
| Tools Required | |
 |
Drill |
 |
Medium Crosshead Screwdriver
|
 |
Large Flathead Screwdriver
|
 |
Spirit Level |
 |
G-Clamp (pair) |
 |
Hammer |
 |
Tape Measure |
 |
Bradawl |
1 2 Assembly Instructions
Note: These instructions show a right hand fixing. Mirror for a left hand fixing. It is advisable to fit the wirework runners at this point. See wirework instructions for further details.
TH Modification required at this stage, see True Handle-less guide for further details.
4
TH Modification required at this stage, see True Handleless guide for further details.
5–6
Do Not Over Tighten Start Locked
7–9
10-11
12
Note: It is advisable to fit the frame to the runners at this point. See wirework instructions for further details.
13-14 Installation Instructions
15-16
17-19
20
Documents / Resources
 |
bsi Pull-Out Base Unit [pdf] Instruction Manual Pull-Out Base Unit, 150 |
