Instruction Manual for bsi models including: Pull-Out Base Unit, 150
Assembly Instructions. 1. 2. 4. 5 ... Note: These instructions show a right hand fixing. ... Follow the instructions supplied with the wirework for wirework assembly .
File Info : application/pdf, 2 Pages, 2.72MB
DocumentDocument150 Pull-Out Base Unit Assembly TH Note: If fitting a "True Handleless" kitchen, some components will differ to those shown in this instruction and will also be packaged separately. Please refer to your True Handleless guide to Receiving for further details on the different components and difference in installation. Components C B A A B Right hand Fixing Left hand Fixing Important Information - True Handleless Kitchens Installers: See Note Above TH Caution: Some pieces of hardware could be hazardous to small children. Keep all these items out of reach and do not leave children unattended in the assembly area. Please read these instructions carefully before proceeding. Refer to the Guide to Receiving and Installing your Kitchen booklet for further information. Note: Due to variation in wall conditions no screws are supplied for fixing the units to the wall. If in doubt consult an expert. Assemble the unit on a clean solid work surface. In the interest of continuing improvements we reserve the right to amend or adjust the specifications without prior notice. Errors and omissions excepted. This unit is fitted with a wirework system. The wirework is supplied separately. These instructions advise when to fit parts of the wirework system. Follow the instructions supplied with the wirework for wirework assembly. Every effort has been made to ensure that this product leaves the factory in perfect condition. In the unlikely event that an item is damaged or incorrect, please contact the customer services department. FM 665131 Note - Fitting Handles: (1) Decide where you are going to position each handle to maintain symmetry around your kitchen. (2) Measure the handle centres and mark off each door/drawer position. (3) Drill through the door/drawer using a fine drill (<2.5mm), then drill back from the rear face using a 4.5mm drill. (4) Attach with the fixings provided with your handle. Ref. No. 150101 Item 3.5x12mm 150202 4x12mm 150201 4x15mm 150199 4.5x45mm Quantity 4 Ref. No. Item 150308 4 150309 16 154047 2 Quantity 2 2 Ref. No. Item 152401 152418 2 152402 Quantity Tools Required 4 5mm 4 Drill 2 Medium Crosshead Screwdriver 154082 154085 8 151500 8 2 Item Quantity Note: These are supplied with the wirework. 6 4.5x15mm Large Flathead Screwdriver 154004 8 151999 4 4.5x13mm 8 Spirit Level 1 2 Assembly Instructions 4 Note: These instructions show a right hand fixing. Mirror for a left hand fixing. It is advisable to fit the wirework runners at this point. See wirework instructions for further details. TH Modification required at this stage, see True Handleless guide for further details. 12 12 21 21 4 4 4 G-Clamp (pair) Hammer Tape Measure Bradawl 3 3 3 4 3 B B 4 4 4 A A 4 4 154085 8 56 3 3 3 12 12 21 TH Modification required at this stage, see True Handleless guide for further details. 1 21 2 1 154082 2 8 154004 3 4.5x15mm 8 Supplied with wirework 6 5 B 5 5 5 A 5 5 A B 5 5 5 6 Do Not Over Tighten Start Locked 79 66mm 8 9 C 7 8 9 8 8 150199 10 11 10 10 2 11 10 10 11 11 11 10 152401 4 150201 16 9 9 9 140mm 66mm 150202 4 9 154047 2 11 152418 4 12 13 14 Installation Instructions Note: It is advisable to fit the frame to the runners at this point. See wirework instructions for further details. 13 150308 2 150309 2 14 14 13 5mm 12 15 16 15 15 15 15 12 Appropriate to wall type (Not supplied) 2 15 151500 17 19 Right hand Fixing 2 17 15 Left hand Fixing Note: Mark the holes for the brackets with a bradawl on the inside of the fascia. Check wirework instructions for measurements. 18 17 4.5x13mm Supplied with wirework 8 20 20 = = 16 16 16 16 152402 150101 17 17 18 20 19 19 Note: Do not over tighten screws 18 or use a power screwdriver. 19 18 19 2 151999 4 19 4 19 13 13 Note: Check wirework instructions for directions on altering fascia position to fit. Ref. 170811 (06)