Brook Wireless Headset User Guide

Wireless Headset
User Guide

Thanks for choosing Brook Wireless Headset
With the right setup, Brook enables every gamer to access the limitless joy of gaming. Brook, Your Game. Our Play.

Prodcut overview

The 2.4G wireless headset features low latency, Hi-Fi sound quality, and stereo output. It is perfect for playing games, listening to music, and other entertainment usage.
It is compatible with PS5, PS4, Nintendo Switch consoles, PC, and Mac.

Power ON / OFF

Hold the power button for 3 seconds until you hear a beep. If the product is not used for 15 minutes, it will automatically shut down.
Pairing
Hold the mic mute button for 5 seconds until you hear beeps. The microphone will be muted when the button is pressed once.
After pairing once, it will be automatically paired when the headset is turned on, and there is no need to re-pair.
※ The headset can be used as a wired headset with the included 3.5mm audio cable. The microphone is not functional in this configuration.
LED ON / OFF

Headset connection to PS5 / PS4

Headset connection to NINTENDO Switch

Headset connection to PC

Headset connection to Mac

NOTE:

• Please fully charge the battery before first use.
• Do not keep the battery in a discharged state for a long time, please allow the battery to retain some power to extend battery life.
• Please unplug the USB charging cable immediately after the headset is fully charged.
• Please put the headset at room temperature
• When the first time used, turn the volume down as low as possible. Then turn it up again.

FCC Compliance statement:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation.
FCC Compliance statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements.
The device can be used in portable exposure conditions without restriction.

P/N: Brook Wireless Headset
M/N: ZPP0061