BRILONER Mini LED Wireless Table Lamp
Product Information
This product is a ceiling-mounted light fixture designed for normal operation. It should only be installed by authorized personnel following the relevant electrical installation regulations. The manufacturer is not liable for injuries or damages resulting from improper use of the lamp.
Specifications
- Intended Use: Ceiling Mounting
- Cleaning Instructions: Use a lint-free cloth
- Safety Precautions: Risk of electric shock, disconnect mains cable before assembly/disassembly, avoid drilling through gas/water/electricity lines
Product Usage Instructions
Safety Precautions
Before connecting the light to the mains, always inspect it for any damage. Do not use the light if you notice any damage to ensure safety.
Assembly and Disassembly
Disconnect the main cable from the power supply before assembling or disassembling the fixture. Switch off the earth leakage circuit breaker/automatic circuit breaker or remove the fuse. Ensure all switches are turned off.
Mounting
Prior to drilling mounting holes, verify that no gas, water, or electricity pipes and wires are in the chosen location. Use suitable attachment material for the subsurface capable of supporting the fixture’s weight.
Maintenance
Clean the lamp using only a dry, lint-free cloth. Avoid contact with water or other liquids for electrical safety.
Usage Restrictions
Do not look directly into the light source to prevent eye strain or damage.
Frequently Asked Questions
- Q: Can this light fixture be used for wall mounting?
- A: No, this product is intended for ceiling mounting only.
- Q: What should I do if I notice damage to the light?
- A: Do not use the light if you observe any damage. Contact customer support for further assistance.
- Q: How should I clean the light fixture?
- A: Use a lint-free cloth to clean the fixture. Avoid using water or other liquids.
Safety directions
Safety directions / Please read this information carefully before installing or using this product. Please keep this user manual for further reference.
- The lamps may only be installed by authorized and qualified technicians according to the valid regulations for electrical installation.
- The manufacturer does not accept any responsibility for injuries or damage resulting from improper use of the light.
- Maintenance of the lights is limited to the surfaces. For electrical safety reasons, this product must not be cleaned with water or other liquids. Use only a dry, lint-free cloth for cleaning.
Caution! Risk of electric shock. Before connecting to the mains, always check the entire light for possible damage. Never use the light if you notice any damage.
Caution! Disconnect the main cable from the power supply before assembling or disassembling. Switch off the earth leakage circuit breaker/automatic circuit breaker or unscrew the fuse. Turn the switches to “OFF”.
Caution! Before drilling the mounting holes, make sure that no gas, water or electricity pipes and wires can be drilled through or damaged in your chosen mounting location.- When mounting, ensure that the attachment material is suitable for the subsurface and that this surface is capable of carrying the weight of the fixture. The manufacturer is not liable for improper installation of the item on the relevant subsurface.
- Before returning, please remove existing batteries or accumulators that are not enclosed by the old device, as well as lamps that can be removed without destroying them, and bring them to a separate collection. Please inquire about these positions at your municipal administration.
- Safety class I
. This light must be connected to the earthed conductor-terminal with the earthed conductor (green-yellow wire) G. - Safety class II
. This light is specially insulated and must not be connected to an earthed conductor. - Protective covers and end covers for mains voltage control parts must always be mounted.
- Do not install the light on a damp or conductive subsurface.
- Please make sure that no cables get damaged during the installation work.
Attention! During operation, lamp parts and illuminants can reach temperatures of more than 60°C. Do not touch during operation! The lamp may only be adjusted and positioned after having cooled down.- This product is intended for normal operation and may only be used for ceiling mounting.
- Do not look directly into the light source (illuminant, LED, etc.).
Documents / Resources
 |
BRILONER Mini LED Wireless Table Lamp [pdf] Instructions Mini LED Wireless Table Lamp, Wireless Table Lamp, Table Lamp |