Bridgtek pH Sensor Adapter
Before we can use this LDSBus device, it has to be configured.
Let’s Get Started!
INSTALLATION INSTRUCTIONS
Step 1.
Connect the LDSBus USB Adapter to the PC with a USB-C to USB-A Cable. (Both to be purchased separately)
Step 2.
Attach one end of the cable provided to the LDSBus device if required.
Step 3.
Attach the other end of the cable to the LDSBus USB Adapter as shown.
Step 4.
Scan the QR code or visit the link provided below :
http://bit.ly/ldsbus-resources
Step 5.
Download the LDSBus Configuration Utility. Complete the installation instructions.
Follow the LDSBus Configuration Utility guide to configure the device name, device address and termination settings.
View the full information of this LDSBus device, application setup and installation guides for further Instructions.
Please visit http://bit.ly/system-warranty or scan the QR code for warranty registration with the UUID and Product Key below
Documents / Resources
 |
Bridgtek pH Sensor Adapter [pdf] Instruction Manual pH Sensor Adapter, pH, Sensor Adapter, Adapter |