BAXTER - logo

Installation instructions:
Note:
Read all instructions thoroughly prior to starting installation.\

Adapter Components:

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components

Step 1: Remove existing Cartridge filter cap and filter.

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 2

Step 2: Ensure that the threads on locking cleat are aligned with threads on adapter body prior to install. (as shown)

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 3

Step 3: Lubricate the face seal on the docking collar (body and tip O-rings will be installed later). Install the Adapter until it bottoms out, then back it out less than 180 degrees to expose an NPT port to be utilized for the Schrader valve. Note the orientation (the opposite one will be plugged with the included hex plug) and remove adapter.

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 4

Step 4: Lubricate the 1/8” hex plug and install in unused port.

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 5

Step 5: Install tip and body O-ring seals and lubricate with engine oil. (Verify Face seal is in place)

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 6

Step 6: Reinstall adapter using 1 1/8” deep socket, to the previously determined orientation.

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 7

Step 7: Lock the adapter in place, by tightening the socket head cap screw with a 5/32 hex wrench.

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 8

Step 8: Lubricate threads on Schrader valve, and install. (use optional 90-degree fitting if needed for better access or clearance)

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 9

Helpful Hint: 90-degree fitting can be installed using a 15/16” 12 point closed end wrench.

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 10

Step 9: Install oil filter with 22 X 1.5 threads, WIX 57045, Purolator PSL22500 or MOBIL1 M1-212 or equivalent. Make certain to lubricate oil filter gasket prior to installation.

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 11

Servicing instructions at Oil Change: Prior to draining engine oil from oil pan, and oil filter removal, apply minimum 30 PSI to the Schrader valve for at least three seconds. This will evacuate the oil retained in the oil filter and cooler. Then, remove oil filter and replace.

BAXTER PERFORMANCE MS 201 BK Cartridge to Spin on Adapter - Adapter Components 12

These instructions are also available on the website.

BaxterPerformanceUSA.com
U.S. Patent 10,195,553

Documents / Resources

BAXTER PERFORMANCE MS-201-BK Cartridge to Spin-on Adapter [pdf] Instruction Manual
MS-201-BK Cartridge to Spin-on Adapter, MS-201-BK, Cartridge to Spin-on Adapter, Spin-on Adapter, Adapter

References

Leave a comment

Your email address will not be published. Required fields are marked *