AVFI Audio BKT-CCPL Codec Plus Mount Instruction Manual

BKT-CCPL Codec Plus Mount
Instruction Manual

Contents hide

BKT-CCPL Codec Plus Mount

BKT-CCPL Codec Plus mount
Thank you for purchasing AVFI’s BKT-CCPL Bracket.
This product is designed to have many mounting options.
Confirm all hardware is included before you begin assembly.
Read these instructions start to finish before beginning installation.
Note: If you cannot understand these instructions or are concerned about safety of the installation contact a qualified contractor or contact AVFI at 1-866-405-0655.

Assembly Instructions

Supplied Parts

Supplied Hardware (Installed on bracket) Slide Codec onto bracket to check fit and orientation (mounting direction)
Key on back of codec should be point upwards or sideways in mounted position. Choose from many mounting methods. ( Some hardware not included) Furniture Wall mount.
Attach to wall using 4 wood screws. (screws not included) Cart/Stand mount.
8mm Machine screws w nuts x4.
Attach to front or rear of Rolling stand.
After mounting the Bracket.
Slide Codec onto bracket and tighten screws on back with small wrench to lock codec from sliding. Done.