AutomatikCentret ETR2 Power Module
INSTALLATION INSTRUCTION
- Push power module into wallbox with mains wiring to the rear.
- The power supply can be installed in a different location from the evotouch unit. Observe correct polarit Red (+), Black (-). X Y not used.
Cable length:- max. 5m 0.5 mm2
- max 10m 10 mm2
- Attach wallplate to wall box or surface (power module remote).
ABOUT COMPANY
- Strandvejen 42
- Saksild
- 8300 Odder
- 86 62 63 64
- www.automatikcentret.dk
- info@automatikcentret.dk
Documents / Resources
 |
AutomatikCentret ETR2 Power Module [pdf] Instructions ETR2 Power Module, ETR2, Power Module, Module |