1. Introduction
Thank you for purchasing the AKIRES Tower Space Heater. This manual provides important information for the safe and efficient operation of your new heater. Please read it thoroughly before use and retain it for future reference.
This ceramic electric heater is designed for indoor use, offering rapid heating, adjustable thermostat control, 120° oscillation, ECO mode, a 24-hour timer, and a realistic 3D flame effect to enhance comfort in various rooms such as bedrooms, living rooms, offices, and garages.
2. Important Safety Information
WARNING: To reduce the risk of fire, electric shock, or injury, always follow these basic precautions:
- Read all instructions before using this heater.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Always unplug the heater when not in use.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped, or damaged in any manner. Discard heater or return to an authorized service facility for examination and/or repair.
- Do not use outdoors.
- This heater is not intended for use in bathrooms, laundry areas, and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over.
- To disconnect heater, turn controls to OFF, then remove plug from outlet.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
- To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
- A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
- Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
- Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
- This heater includes a Tip-Over Protection switch that automatically shuts off the heater if it is accidentally knocked over.
- The heater is equipped with an Overheat Protection system that will shut off the heater if it becomes too hot.
- The unit features V0 Flame-Retardant Materials for added safety.
- A Child Lock function is available to prevent accidental setting changes.
Figure 2.1: Safety features including tip-over protection and child lock.
3. Product Overview
The AKIRES Tower Space Heater combines efficient heating with user-friendly controls and safety features. It features a sleek tower design with a digital display and a realistic 3D flame effect at the base.
Figure 3.1: AKIRES Tower Space Heater.
3.1 Components
- Control Panel: Touch-sensitive buttons on the top for power, mode, oscillation, timer, and temperature adjustment.
- Digital Display: Shows current temperature, timer settings, and mode.
- Heating Element: Ceramic PTC heating for rapid and efficient warmth.
- Air Outlet: Located at the front, distributing warm air.
- 3D Flame Effect: Simulated fireplace at the base for ambiance.
- Sturdy Base: Provides stability for the tower design.
- Remote Control: For convenient operation from a distance.
Figure 3.2: Control panel and remote control.
4. Setup
- Unpack: Carefully remove the heater from its packaging. Retain packaging for storage.
- Placement: Place the heater on a firm, level surface. Ensure it is at least 3 feet (0.9 m) away from walls, furniture, and other combustible materials. Do not place it on soft surfaces like rugs or carpets that could block air vents.
- Power Connection: Plug the heater directly into a 120V AC, 60Hz wall outlet. Do not use extension cords or power strips.
5. Operating Instructions
The heater can be operated using the touch control panel on top of the unit or the included remote control.
5.1 Power On/Off
- Press the Power button (
) on the control panel or remote to turn the heater on or off.
5.2 Temperature Adjustment
- When the heater is on, press the + or - buttons to set your desired temperature between 50°F and 99°F. The heater will cycle on and off to maintain the set temperature.
Figure 5.1: Precise thermostat control.
5.3 Heating Modes
- Press the Mode (M) button to cycle through available heating modes:
- High Heat (1500W): Provides maximum warmth for rapid heating.
- Low Heat: Offers efficient comfort with reduced power consumption.
- ECO Mode: Automatically adjusts heating power to maintain the set temperature, optimizing energy savings.
Figure 5.2: ECO Mode for energy efficiency.
5.4 Oscillation Function
- Press the Oscillation button (
) to activate the 120° wide-angle oscillation, distributing heat evenly across the room. Press again to stop oscillation.
Figure 5.3: 120° wide-angle oscillation.
5.5 24-Hour Timer
- Press the Timer button (
) to set the heater to automatically turn off after a specified period (1-24 hours). Each press increases the timer by one hour.
Figure 5.4: Programmable 24-hour timer.
5.6 Child Lock
- To activate the Child Lock, press and hold the Child Lock button (often combined with another function or a dedicated lock icon) for 3 seconds. The control panel will become unresponsive to touch.
- To deactivate, press and hold the Child Lock button again for 3 seconds.
5.7 3D Flame Effect
- The realistic 3D flame effect can be turned on or off independently of the heating function by pressing the Flame button (
) on the control panel or remote.
5.8 Video Demonstration
Video 5.1: An official product video demonstrating the AKIRES Large Space Heater's features and operation, including instant warmth, safety features, and quiet operation.
6. Maintenance
Regular maintenance ensures optimal performance and longevity of your heater.
6.1 Cleaning
- Before Cleaning: Always turn off the heater and unplug it from the wall outlet. Allow it to cool completely before cleaning.
- Exterior Cleaning: Use a soft, damp cloth to wipe the exterior surfaces of the heater. Do not use abrasive cleaners or solvents, as these may damage the finish.
- Air Intake/Outlet: Use a vacuum cleaner with a brush attachment to gently remove dust and lint from the air intake and outlet grilles. Ensure these areas are clear of obstructions.
- Storage: If storing the heater for an extended period, clean it thoroughly and store it in its original packaging in a cool, dry place.
CAUTION: Do not immerse the heater in water or allow water to drip into the interior of the heater, as this could create an electric shock hazard.
7. Troubleshooting
If your heater is not operating correctly, please refer to the following common issues and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Heater does not turn on. | No power to the unit. Tip-over switch activated. Overheat protection activated. | Ensure the power cord is securely plugged into a working outlet. Place the heater on a firm, level surface. If it was tipped, stand it upright and it should reset. Unplug the heater, wait 10-15 minutes for it to cool down, then plug it back in. Clear any obstructions from air vents. |
| Heater produces cool air only. | Heating element malfunction. Temperature setting too low. | If the heater consistently blows cool air, contact customer support. Increase the desired temperature setting. Ensure the ambient temperature is below the set temperature. |
| Heater stops unexpectedly. | Overheat protection activated. Tip-over switch activated. Timer function engaged. | Unplug and allow to cool. Check for blocked air vents. Ensure the heater is upright on a stable surface. Check if the timer is set to turn off. Adjust or disable the timer. |
| Oscillation not working. | Oscillation function not activated. | Press the oscillation button to activate. If it still doesn't work, contact customer support. |
If you experience issues not listed here, or if the problem persists after attempting the solutions, please contact AKIRES customer support.
8. Specifications
| Feature | Detail |
|---|---|
| Brand | AKIRES |
| Model | B0FNQZFWNY |
| Color | Black |
| Form Factor | Tower |
| Indoor/Outdoor Usage | Indoor |
| Product Dimensions | 12.13"D x 12.13"W x 33.46"H |
| Item Weight | 7.98 pounds |
| Fuel Type | Electric |
| Voltage | 120 Volts (AC) |
| Heating Power | 1500W (High Mode) |
| Temperature Range | 50°F to 99°F |
| Oscillation | 120° |
| Timer | 24-hour programmable |
| Safety Features | Overheat Protection, Tip-Over Protection, Child Lock, V0 Flame-retardant materials |
| Special Features | ECO Mode, Remote Control, 3D Flame Illusion, Dust Filter |
9. Warranty and Support
AKIRES products are designed and manufactured to the highest quality standards. For information regarding warranty coverage, please refer to the warranty card included with your product or visit the official AKIRES website.
If you have any questions, require technical assistance, or need to report an issue, please contact AKIRES customer support. Contact details can typically be found on the product packaging, in the included documentation, or on the AKIRES brand store page.
Online Support: AKIRES Brand Store on Amazon