Important Safety Information
This product is not a toy and is not intended for children under 14 years of age. Always operate the RC car in a safe environment, away from people, pets, and obstacles. Read all instructions before use.
What's in the Box
- Battery
- Charging Cable
- Product Manual
- Remote
- Hexagonal Wrench

Setup
1. Initial Inspection
Carefully unpack all components and inspect for any visible damage. Ensure all parts listed in "What's in the Box" are present.
2. Battery Charging and Installation
Connect the provided charging cable to the 3S LiPo battery and a suitable USB power source. Charge the battery fully before first use. Once charged, install the battery securely into the RC car's battery compartment. Ensure the battery is properly connected to the ESC.
3. Transmitter Setup
Install batteries into the 2.4GHz 3-Channel Radio transmitter. Power on the transmitter first, then the RC car. The transmitter features ST/TH Trim functions for fine-tuning steering and throttle. For new users, the throttle can be limited to 70% for easier control. Refer to the transmitter diagram for control identification.

Operating Instructions
1. Basic Operation
Use the trigger on the transmitter to control forward and reverse movement. Push the trigger forward for reverse/brake, and pull it back for acceleration. The steering wheel controls left and right turns. Practice in an open area to familiarize yourself with the controls.
2. Speed Control and Unlocking
The RC car has a factory speed limit of approximately 33 mph. To unlock the full speed potential (up to 50 mph with an Angry Snail 3S2000 battery, or 45+ mph with the included 3S battery), press the SET button on the ESC 5 times. This will allow the car to reach its maximum speed capabilities.

3. All-Terrain Driving
The HYPER GO RC car is designed for various terrains. Its multi-terrain airless style tires (111mm diameter) are suitable for grass, gravel, and dirt roads. The included extra paddle tires are ideal for extreme conditions like snow, sand, and mud, providing enhanced traction. The adjustable, oil-filled shocks ensure stable driving even at high speeds over uneven surfaces.

Maintenance
1. General Cleaning
After each use, especially in dirty or wet conditions, clean the RC car to remove dirt, dust, and debris. Use a soft brush or compressed air for hard-to-reach areas. Avoid using water directly on electronic components unless specified as waterproof.
2. Component Inspection
Regularly inspect the steel differential, powder metallurgy transmission spur and pinion, heavy-duty drivetrain, and steel universal telescopic drive shaft for wear or damage. Check the aluminum alloy chassis for any bends or cracks. Ensure all screws and fasteners are tight.

3. Shock Absorbers
The oil-filled shocks are designed for optimal performance. Periodically check them for leaks or reduced damping. If necessary, refill or replace the shock oil according to hobby-grade RC maintenance practices.

Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Car does not respond to transmitter | Low battery in car or transmitter; Not properly bound; Power switch off. | Charge batteries; Re-bind transmitter and receiver; Ensure both are powered on. |
| Reduced speed or power | Low battery; Speed limit engaged; Motor/ESC overheating. | Recharge battery; Unlock speed limit (press SET 5 times); Allow components to cool down. |
| Car pulls to one side | Steering trim incorrect; Damaged steering components. | Adjust ST Trim on transmitter; Inspect steering servo and linkages for damage. |
| Unstable at high speeds | Improper shock setup; Loose components; Uneven tire wear. | Check and adjust oil-filled shocks; Tighten all fasteners; Inspect tires. |
Specifications
- Product Dimensions: 12.71 x 8.66 x 4.64 inches
- Item Weight: 5.7 pounds
- Item Model Number: H14BMV3
- Manufacturer Recommended Age: 14 years and up
- Batteries: 1 Lithium Ion battery required (included)
- Motor: Hobby 2852 4400KV, 4 pole high-torque brushless motor
- ESC: Independent 45A ESC (compatible 2S/3S battery)
- Chassis: 6061 Aluminum Alloy
- Tires: Multi-terrain airless style (111mm diameter), extra paddle tires included
- Shocks: Adjustable, oil-filled
- Transmitter: 300+ FT 2.4GHz 3-Channel Radio
Warranty and Support
For warranty information, technical support, or replacement parts, please contact HYPER GO customer service directly. Refer to the packaging or the official HYPER GO website for contact details.
Manufacturer: HYPER GO







