RDSJ SUN-INTE-172

RDSJ 3400mAh Vacuum Battery Replacement

Instruction Manual

1. Introduction

This manual provides essential information for the safe and effective use of your RDSJ 3400mAh Li-ion replacement battery. This battery is designed for specific robot vacuum cleaner models, ensuring optimal performance and compatibility. Please read this manual thoroughly before installation and use.

RDSJ 3400mAh Li-ion replacement battery with included tools

Figure 1: The RDSJ 3400mAh Li-ion replacement battery, shown with a small screwdriver and cleaning brush, indicating the product package contents.

2. Product Features

Diagram showing multiple protection features of the battery

Figure 2: Illustration detailing the multiple safety protections integrated into the battery, including over-charge, over-discharge, over-voltage, over-current, and over-temperature protection.

3. Specifications

SpecificationValue
Battery TypeLi-ion
Voltage14.4V/14.8V
Capacity3400mAh / 48.96Wh
Model NumberSUN-INTE-172
Item Weight7.8 ounces
Package Dimensions3.15 x 2.36 x 1.97 inches
ManufacturerRDSJ
Product parameters label showing voltage and capacity

Figure 3: A close-up view of the battery label, highlighting its voltage (14.4V/14.8V) and capacity (3400mAh/48.96Wh).

4. Compatibility

This replacement battery is compatible with the following robot vacuum cleaner models:

Images of compatible robot vacuum cleaners

Figure 4: Visual representation of the compatible robot vacuum cleaner models, including the iHome iHRV6-BLK and Tesvor SUN-INTE-172.

5. Safety Information and Warnings

To ensure safe operation and prevent potential hazards, please adhere to the following warnings:

Back of the battery with caution label

Figure 5: The reverse side of the battery, displaying a caution label with important safety instructions regarding dry location use, disposal, and handling.

6. Installation

The battery is designed for easy installation, typically taking around 2 minutes. Refer to your robot vacuum cleaner's original instruction manual for specific battery compartment access and removal procedures. Ensure the connector type matches your original battery before installation.

  1. Power off your robot vacuum cleaner and unplug it from any charging base.
  2. Locate the battery compartment, usually on the underside of the robot.
  3. Open the battery compartment cover (may require a screwdriver, often included).
  4. Carefully disconnect the old battery's plug from the robot's port.
  5. Remove the old battery.
  6. Connect the new RDSJ battery's plug to the robot's port, ensuring a secure fit.
  7. Place the new battery into the compartment.
  8. Close the battery compartment cover and secure it.
Close-up of battery connector

Figure 6: A detailed view of the battery's connector, emphasizing the importance of confirming it matches the original battery's connector type for proper installation.

7. Operating and Charging

Once installed, the battery will power your robot vacuum cleaner. For optimal performance and longevity:

Bar chart showing low self-discharge rate

Figure 7: A bar chart illustrating the battery's low self-discharge characteristic, showing that it retains approximately 80% of its capacity after one year of storage.

8. Maintenance and Care

Proper care will extend the life of your battery:

9. Troubleshooting

If you encounter issues with your new battery, consider the following:

10. Warranty and Support

For warranty information regarding your RDSJ replacement battery, please refer to the product packaging or contact the seller directly. Keep your proof of purchase for any warranty claims.

For technical support or further assistance, please reach out to RDSJ customer service through the platform where you purchased the product.