Introduction
This document provides instructions for the installation and maintenance of the SHAUOTR Replacement Filter, compatible with the Winix HR900 Air Purifier. This filter is designed to maintain the air purification performance of your device by capturing airborne particles and absorbing odors.
Setup: Filter Installation
Follow these steps to correctly install the replacement filter in your Winix HR900 Air Purifier:
- Power Off and Unplug: Before beginning, ensure your air purifier is turned off and unplugged from the power outlet for safety.
- Remove Bottom Cover: Carefully turn the air purifier upside down. Locate and twist the bottom cover counter-clockwise to unlock and remove it.
- Remove Old Filter: Gently pull out the used filter from the air purifier. Dispose of the old filter responsibly.
- Unpack New Filter: Remove the new SHAUOTR replacement filter from its packaging.
- Insert New Filter: Align the new filter with the internal compartment of the air purifier and slide it in. Ensure it sits securely.
- Replace Bottom Cover: Place the bottom cover back onto the air purifier, align the tabs, and twist clockwise to lock it into place.
- Reset Filter Indicator (if applicable): Refer to your Winix HR900 Air Purifier's user manual for instructions on how to reset the filter replacement indicator light, if your model has this feature.
Visual Aid:

Image: SHAUOTR Replacement Filter, showing its cylindrical shape and pleated design.
For a visual guide on filter replacement, please refer to the video below. While the specific air purifier model shown in the video may vary (C610), the general steps for replacing a cylindrical filter are similar.
Video: General guide on how to replace an air purifier filter. This video demonstrates the process of removing and installing a cylindrical filter, which is applicable to many air purifier models including the Winix HR900.
Operating Principle
The SHAUOTR Replacement Filter for Winix HR900 Air Purifier utilizes a multi-stage filtration system to effectively clean the air. It typically consists of two primary layers:
- HEPA Filter: This layer is designed to capture ultrafine particles unseen by the human eye, such as PM2.5, pollen, dust mites, and pet dander. It works by trapping these microscopic allergens and pollutants.
- Activated Carbon Filter: This layer is engineered to absorb gases, volatile organic compounds (VOCs), smoke, and various odors from the air, contributing to a fresher indoor environment.
Filter Layer Diagram:

Image: Diagram illustrating how air passes through the HEPA filter (capturing particles) and then the Activated Carbon filter (absorbing gases and odors).
Maintenance
Regular filter replacement is crucial for maintaining optimal air purification performance and ensuring fresh indoor air quality. The lifespan of the filter can vary based on usage and air quality conditions.
- Replacement Frequency: It is generally recommended to replace the filter every 6 to 12 months. However, always refer to your Winix HR900 Air Purifier's specific guidelines for filter replacement intervals and indicator lights.
- Filter Condition: Over time, the filter will accumulate pollutants and its effectiveness will decrease. A noticeable reduction in air flow or an increase in odors may indicate that the filter needs to be replaced sooner.
- Cleaning: The HEPA and Activated Carbon filters are not washable and should not be cleaned with water or vacuumed, as this can damage the filter media and reduce efficiency. Replace the entire filter unit when necessary.
Troubleshooting
If you experience issues after replacing your filter, consider the following:
- Air Quality Not Improving: Ensure the filter is installed correctly and the bottom cover is securely locked. Verify that the air purifier is operating on the appropriate setting for your room size and air quality needs.
- Unusual Noise: Check if the filter is seated properly within the air purifier. A loose filter can cause vibrations or unusual sounds.
- Filter Indicator Light Remains On: If your air purifier has a filter reset function, ensure you have followed the manufacturer's instructions to reset it after installing the new filter.
Specifications
| Brand | SHAUOTR |
| Compatible Model | Winix HR900 Air Purifier |
| Part Numbers | 1712-0093-00, AZPU370-IWE |
| Filter Type | HEPA and Activated Carbon |
| Item Weight | 50 Grams |
| Number of Items | 1 |
Warranty and Support
For specific warranty information regarding this replacement filter, please refer to the product listing or contact the seller directly. For support related to the operation or maintenance of your Winix HR900 Air Purifier, please consult the original air purifier's user manual or contact Winix customer service.