1. Introduction
Thank you for choosing NARWAL Floor Cleaning Tablets. These tablets are designed to enhance the cleaning performance of your compatible NARWAL robot vacuum and mop, providing a fresh and hygienic clean for your floors.
Image 1: A single NARWAL Floor Cleaning Tablet, illustrating its compact form.
2. Compatibility
These cleaning tablets are specifically formulated for use with the following NARWAL robot vacuum and mop models:
- Narwal Freo Pro
- Narwal Freo X10 Pro
Please verify your robot model before use to ensure proper function and avoid potential damage.
3. Safety Information
Observe the following safety precautions when handling and storing the cleaning tablets:
- Keep out of reach of children and pets: Store tablets in a secure location to prevent accidental ingestion.
- Avoid contact with eyes and skin: In case of contact, rinse thoroughly with water. If irritation persists, seek medical attention.
- Do not ingest: If swallowed, do not induce vomiting. Seek immediate medical attention.
- Store in a cool, dry place: Keep tablets in their original packaging away from moisture and direct sunlight.
4. Setup and Usage
Follow these steps to use the NARWAL Floor Cleaning Tablets with your robot vacuum:
- Locate the Clean Water Tank: Identify the clean water tank on your compatible NARWAL robot vacuum and mop. Refer to your robot's specific user manual if needed.
- Fill the Tank with Water: Fill the clean water tank with fresh water as you normally would for a mopping cycle.
- Add One Cleaning Tablet: Carefully drop one NARWAL Floor Cleaning Tablet into the filled clean water tank. The tablet will begin to dissolve.
- Close the Tank: Securely close the clean water tank and place it back into your robot vacuum.
- Start Cleaning: Initiate a cleaning cycle on your robot vacuum as per its operating instructions. The dissolved cleaning agents will be dispensed during the mopping process.
Image 2: Visual guide demonstrating the process of adding a cleaning tablet to the water tank.
5. Maintenance and Storage
- Clean Water Tank: After each use, empty any remaining water from the clean water tank and rinse it thoroughly.
- Dirty Water Tank: Regularly empty and clean the dirty water tank of your robot vacuum to prevent odor and bacterial growth.
- Mop Pads: Clean or replace mop pads as recommended by your robot vacuum's manual.
- Storage: Store unused tablets in their original packaging in a cool, dry place, away from direct sunlight and moisture.
6. Troubleshooting
| Issue | Possible Cause | Solution |
|---|---|---|
| Streaks on floor after mopping | Tablet may not be fully dissolved or concentration is too high. | Ensure the tablet has fully dissolved before starting the cleaning cycle. If streaks persist, consider breaking the tablet in half for a lighter concentration, especially for smaller areas or lighter cleaning needs. |
| Tablet not dissolving properly | Insufficient water temperature or tablet not fully submerged. | Use room temperature water. Ensure the tablet is fully submerged in the clean water tank. Allow a few minutes for complete dissolution before starting the robot. |
| No noticeable cleaning improvement | Incorrect tablet usage or heavily soiled floors. | Confirm one tablet is used per clean water tank refill. For heavily soiled areas, a pre-clean or multiple passes may be required. Ensure mop pads are clean. |
7. Product Specifications
| Feature | Detail |
|---|---|
| Product Name | NARWAL Floor Cleaning Tablets |
| Model Number | YJCC023 |
| Quantity | 24 tablets per box |
| Recommended Dosage | 1 tablet per refill of the clean water tank |
| Compatible Devices | Narwal Freo Pro, Narwal Freo X10 Pro |
| Dimensions (Box) | 10.4L x 3W x 16.5H centimetres |
8. Customer Support
For further assistance, questions, or support regarding your NARWAL Floor Cleaning Tablets or compatible robot vacuum, please visit the official NARWAL website or contact customer service.
Official NARWAL Website: www.narwal.com