Fullware Spider Hero RC Boat (Model H162) Instruction Manual

1. Safety Information

Read all instructions before operating the RC boat. Failure to follow these instructions may result in injury or damage to the product.

Recommended for ages 3 and up. Adult supervision is required for children.
Do not operate the boat in saltwater. Use only in fresh water (pools, lakes, ponds).
Keep fingers, hair, and loose clothing away from the propellers when the boat is powered on.
Ensure the battery compartment is securely sealed before placing the boat in water.
Do not touch the motor immediately after use, as it may be hot.
Always remove batteries from the boat and remote control when not in use.
Dispose of batteries properly according to local regulations.

2. Package Contents

Verify that all items are present in the package:

Spider Hero RC Boat (Model H162)
2.4GHz Remote Control
Rechargeable Lithium-Ion Batteries (2 included for the boat)
USB Charging Cable
Instruction Manual (this document)

Image: Fullware Spider Hero RC Boat and Remote Control in packaging.

3. Setup

3.1 Charging the Boat Batteries

Locate the two rechargeable Lithium-Ion batteries for the boat.
Connect each battery to the provided USB charging cable.
Plug the USB cable into a standard USB power adapter (not included).
The indicator light on the USB cable will show charging status (e.g., red for charging, green for fully charged).
Charging time is approximately 60-90 minutes per battery. Each fully charged battery provides about 15 minutes of runtime.

Video: This video demonstrates the installation of the rechargeable battery into the Fullware Spider Hero RC Boat. It shows how to open the boat's compartment, connect the battery, and secure the cover.

3.2 Installing Boat Batteries

Carefully open the deck hatch latch on the top of the boat.
Remove the leakproof hatch cover.
Connect a fully charged Lithium-Ion battery to the boat's power connector.
Place the battery inside the compartment.
Ensure the leakproof hatch cover is securely re-attached and the deck hatch latch is closed to prevent water entry.

Fullware Spider Hero RC Boat with its remote control, showing the top hatch.

Image: The Fullware Spider Hero RC Boat with its remote control, highlighting the top hatch where the battery is installed.

3.3 Installing Remote Control Batteries

The remote control requires 1.5V AA batteries (not included).

Locate the battery compartment on the back of the remote control.
Open the battery cover.
Insert the required AA batteries, ensuring correct polarity (+/-).
Close the battery cover securely.

4. Operating Instructions

4.1 Pairing the Remote Control with the Boat

Ensure both the boat and remote control have fresh or fully charged batteries installed.
Place the boat in fresh water. The water-sensing safety switch will activate the boat's power.
Turn on the remote control. The indicator light on the remote will flash.
The remote control will automatically pair with the boat. Once paired, the indicator light on the remote will become solid.

4.2 Basic Controls

Throttle Trigger: Pull to move forward, push to move backward.
Steering Wheel: Turn left to steer the boat left, turn right to steer the boat right.
Water Spray Button: Press the designated button on the remote to activate the water spray function.

Fullware Spider Hero RC Boat in water with LED lights on.

Image: The Fullware Spider Hero RC Boat operating in water, showcasing its built-in LED lights.

4.3 Capsize Recovery Function

If the boat flips over, press the recovery button on the remote control multiple times. The boat will gradually right itself, allowing you to continue operation without manual intervention.

Diagram illustrating the capsize recovery function of the RC boat.

Image: A visual representation of the boat's self-righting mechanism after capsizing.

4.4 Low Battery Alert

When the boat's battery power is low, the remote control will flash red and emit an audible alert. This indicates it's time to bring the boat back to shore for battery replacement or recharging before it stops operating.

5. Maintenance

After each use, remove the boat from the water and thoroughly dry it with a soft cloth.
Open the battery compartment and dry any moisture inside.
Remove the boat batteries and remote control batteries if storing for an extended period.
Inspect the propellers for any debris (e.g., weeds, string) and carefully remove them.
Store the boat and remote control in a cool, dry place away from direct sunlight.

6. Troubleshooting

Problem	Possible Cause	Solution
Boat does not move.	Boat not in water (water-sensing switch). Boat battery is low or not connected. Remote control batteries are low or not installed. Boat and remote not paired.	Place boat in water. Charge/connect boat battery. Replace/install remote control batteries. Re-pair boat and remote (see Section 4.1).
Boat moves slowly or erratically.	Low boat battery. Debris caught in propellers. Operating range exceeded.	Recharge boat battery. Remove debris from propellers. Bring boat closer to the remote control.
Water spray function not working.	Low boat battery. No water in the boat's internal reservoir (if applicable).	Recharge boat battery. Ensure boat is in water for the spray function to draw water.

7. Specifications

Model: H162
Brand: Fullware
Product Dimensions: 5 x 3 x 11 inches
Item Weight: 1.23 pounds
Control Frequency: 2.4GHz
Control Range: Approximately 164 feet (50 meters)
Boat Battery: 1 Lithium Ion battery required (2 included), each providing ~15 minutes runtime.
Remote Control Battery: 1.5V AA batteries (not included)
Features: LED Lights, Water Spray Function, Capsize Recovery, Water-Sensing Safety Switch, Low Battery Alarm.
Recommended Age: 3+ years
Manufacturer: SHANTOU SKYTECH TECHNOLOGY INDUSTRIAL INC.

8. Warranty and Support

For warranty information or technical support, please contact Fullware customer service through the retailer where the product was purchased or visit the official Fullware website. Keep your purchase receipt as proof of purchase.

Fullware H162