PANICAL Motorcycle Windshield Accessories Instruction Manual

Introduction

This instruction manual provides detailed information for the installation, operation, and maintenance of your PANICAL Motorcycle Rearview Mirror Windshield Accessories. Designed specifically for Honda GoldWing 1800 F6B GL1800 models from 2018-2025, these accessories enhance rider comfort by reducing wind drag and stress on shoulders and upper arms.

Product Overview and Components

The PANICAL Motorcycle Rearview Mirror Windshield Accessories are crafted from high-quality PC material using an injection molding process, ensuring durability and a precise fit. The transparent design integrates seamlessly with your motorcycle's aesthetics.

What's in the Box:

• 2 x Windshield Accessories (Left and Right)
• Adhesive strips for installation
• Cleaning wipe

Specifications

Installation Guide

Follow these steps for a secure and proper installation of your PANICAL rearview mirror windshield accessories.

1. Prepare the Surface: Ensure the installation area on your motorcycle (near the rearview mirrors, as indicated in Figure 3) is clean and dry. Use the provided cleaning wipe to remove any dirt, grease, or residue. Allow the surface to dry completely before proceeding.

   

2. Apply Adhesive: Carefully peel off the backing from one side of the adhesive strip. Align the adhesive strip precisely with the designated area on the back of one windshield accessory. Press firmly to ensure good adhesion.
3. Position and Attach: Peel off the remaining backing from the adhesive strip on the accessory. Carefully position the accessory onto the prepared surface of your motorcycle, ensuring correct alignment. Press down firmly and hold for at least 30 seconds to secure it in place. Apply even pressure across the entire surface of the adhesive.
4. Repeat for Second Side: Repeat steps 2 and 3 for the second windshield accessory on the opposite side of your motorcycle.
5. Curing Time: For optimal adhesion, avoid washing your motorcycle or exposing the installed accessories to heavy rain for at least 24-48 hours after installation. This allows the adhesive to fully cure.

   

Operating Principle

These windshield accessories are designed to redirect airflow around the rider's hands, shoulders, and upper arms. By creating a more aerodynamic profile, they effectively reduce wind drag and buffeting, leading to a more comfortable riding experience, especially at higher speeds or during long journeys.

Care and Maintenance

To ensure the longevity and clarity of your PANICAL windshield accessories, follow these maintenance guidelines:

• Cleaning: Clean the accessories regularly with a soft cloth and mild soap and water. Avoid abrasive cleaners or harsh chemicals that could scratch or damage the PC material.
• Inspection: Periodically inspect the accessories and the adhesive bond for any signs of loosening or damage. Re-secure or replace if necessary.
• Storage: If removing the accessories for storage, clean them thoroughly and store them in a protective bag or container to prevent scratches.

Troubleshooting

Common Issues and Solutions:

• Accessory not adhering properly:
  • Ensure the surface was thoroughly cleaned and dry before application.
  • Verify that sufficient pressure was applied during installation.
  • Allow adequate curing time (24-48 hours) before exposing to moisture or stress.
  • If the issue persists, the adhesive may need to be replaced.
• Reduced wind deflection:
  • Confirm the accessories are installed in the correct orientation and position as shown in the installation guide.
  • Ensure both left and right accessories are installed.

Warranty and Support

For any questions, concerns, or support regarding your PANICAL Motorcycle Windshield Accessories, please contact the seller directly through the platform where the purchase was made. Refer to your purchase documentation for specific warranty details, if applicable.

Manufacturer: PANICAL

Model Number: KY DS20200792