1. Introduction
This manual provides essential information for the safe and effective use of your KUNPHY Ultrasonic Jewelry Cleaner, model BCM-187. This device utilizes ultrasonic waves to clean various items such as jewelry, eyeglasses, and small accessories, offering a thorough cleaning process.
2. Safety Information
Please read all safety instructions before operating the device to prevent injury or damage.
- Do not immerse the main unit in water or other liquids.
- Ensure the power cord is not damaged and is properly connected to a suitable power outlet.
- Keep the device out of reach of children.
- Do not operate the cleaner without water in the tank.
- Avoid cleaning items that are sensitive to ultrasonic vibrations, such as certain types of pearls, emeralds, or glued items. Consult a jeweler if unsure.
- Unplug the device when not in use and before cleaning.
3. Package Contents
Verify that all items are present in the package:
- KUNPHY Ultrasonic Jewelry Cleaner (BCM-187)
4. Product Overview
The KUNPHY Ultrasonic Jewelry Cleaner features a compact design with a stainless steel cleaning tank and a simple one-touch operation button. It is equipped with a transparent lid to observe the cleaning process.
5. Setup and Operation
Follow these steps for initial setup and to operate your ultrasonic cleaner:
- Fill the Tank: Open the lid and pour tap water into the stainless steel tank. Do not exceed the maximum water level indicator.
- Place Items: Carefully place the items you wish to clean into the water. Ensure items are fully submerged but not overcrowded.
- Add Cleaning Solution (Optional): For enhanced cleaning results, add a few drops of liquid dish soap or a specialized KUNPHY cleaning solution to the water.
- Start Cleaning: Close the lid and press the one-touch ON/OFF button. The indicator light will illuminate, and the cleaning cycle will begin. The device operates with a 3-minute cleaning cycle.
- Finish Cleaning: Once the cycle is complete, the device will automatically stop. Open the lid, carefully remove your items, and rinse them under clean water. Dry with a soft cloth.
Items Suitable for Cleaning:
- Jewelry (rings, necklaces, earrings, bracelets)
- Eyeglasses and sunglasses
- Watch coins (waterproof watches only)
- Dentures and retainers
- Small metal items
Cleaning Performance:
The cleaner operates at 46KHz, providing 360-degree deep cleaning. The process is designed to be gentle yet effective, removing dirt and grime from hard-to-reach areas without causing damage.
6. Maintenance
Proper maintenance ensures the longevity and optimal performance of your cleaner.
- After Each Use: Unplug the device. Empty the water from the tank and wipe the interior with a soft, dry cloth.
- Exterior Cleaning: Wipe the exterior of the unit with a soft, damp cloth. Do not use abrasive cleaners or immerse the unit in water.
- Storage: Store the cleaner in a cool, dry place when not in use.
7. Troubleshooting
If you encounter issues with your KUNPHY Ultrasonic Jewelry Cleaner, refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Device does not turn on. | No power supply. | Ensure the power cord is securely plugged into both the device and a working electrical outlet. |
| Cleaning performance is poor. | Insufficient water or no cleaning solution. | Ensure the tank is filled to the appropriate level. Consider adding a few drops of liquid dish soap or KUNPHY cleaning solution. |
| Red indicator light is flashing. | Overheat protection activated. | Unplug the device and allow it to cool down for a few minutes before attempting to use it again. |
8. Specifications
- Model: BCM-187
- Tank Capacity: 12 oz (350ml)
- Ultrasonic Frequency: 46KHz
- Cleaning Cycle: 3 minutes (one-touch operation)
- Product Dimensions: 7 x 3 x 3 inches
- Weight: 1.1 Pounds
- Tank Material: SUS 304 Stainless Steel
- Noise Level: Less than 45dB (low-noise design)
9. Warranty and Support
KUNPHY provides a 12-month warranty for this product. For any questions or support needs, please contact KUNPHY customer service.
To contact support, navigate to your Amazon account:
- Go to Account.
- Select Orders.
- Find your order for the KUNPHY Ultrasonic Jewelry Cleaner and click on Order Detail.
- Locate the 'Sold by: KUNPHY' section and click Ask a question.
