BuSwift 320P Robotic Pool Cleaner User Manual

1. Introduction

The BuSwift 320P Robotic Pool Cleaner is designed for efficient and autonomous cleaning of above-ground pools up to 850 sq.ft. Featuring a hydro-dynamic design, superior suction, and advanced DirtLock 2.0 technology, it effectively captures leaves, debris, and fine particles, ensuring a clean pool with minimal effort. This cordless unit offers convenient operation and automatic parking when the battery is low.

Figure 1: BuSwift 320P Robotic Pool Cleaner

2. Setup

Before first use, ensure the unit is fully charged. The BuSwift 320P features a built-in 4400mAh battery that requires approximately 2.5 hours for a full recharge.

Initial Charging:

1. Locate the charging port on the unit.
2. Connect the provided charger to the unit and a power outlet.
3. Allow the unit to charge until the LED indicator shows a full charge (refer to LED indicator section for details).

First Time Use:

1. Place the pool vacuum in the pool.
2. Turn it on to initiate autonomous cleaning.
3. Retrieve it when it automatically parks at the pool's edge due to low battery.

Figure 2: Robotic pool cleaner charging near the pool.

3. Operating Instructions

The BuSwift 320P is designed for simple, one-button operation. Once placed in the water and activated, it will autonomously navigate and clean the pool floor.

Starting Operation:

• Ensure the pool cleaner is fully charged.
• Submerge the cleaner into the pool. It will activate automatically or via a single button press (refer to specific button location on your unit).
• The cleaner will begin its cleaning cycle, covering the pool floor.

Smart Sensor & Auto-Parking:

The updated sensor technology allows the Bubot 300P to automatically park at the pool's edge when its battery is low. This feature simplifies retrieval after the cleaning cycle is complete.

LED Indicator:

The device is equipped with four 4-color LED lights that communicate its status, including battery level and operational mode. Consult the quick start guide for specific light patterns and their meanings.

Figure 3: Cordless design for hassle-free operation in above-ground pools.

4. Maintenance

Regular maintenance ensures optimal performance and longevity of your BuSwift 320P Robotic Pool Cleaner.

Cleaning the Filter and Chassis:

The advanced DirtLock Tech 2.0 system efficiently captures debris. After each use, it is recommended to clean the filter and chassis. This process is designed to be simple and stress-free.

• Remove the cleaner from the pool.
• Open the unit to access the filter basket.
• Remove the filter and rinse both the filter and the internal chassis thoroughly with a hose.
• Ensure all debris is removed before reassembling the unit.

Figure 4: Easy maintenance: Rinse both the filter and chassis with a hose.

5. Troubleshooting

If you encounter issues with your BuSwift 320P, please refer to the following common troubleshooting tips:

• Unit not moving or cleaning: Ensure the battery is fully charged. Check for any obstructions in the suction port or wheels.
• Poor suction: Clean the filter thoroughly. Ensure the unit is fully submerged and operating in the correct water depth.
• Unit not parking at edge: Verify the smart sensor is clean and unobstructed. Ensure the pool size is within the recommended 850 sq.ft.
• Short operating time: Fully charge the unit. Battery performance can be affected by extreme temperatures; ensure storage temperature is within recommended range (32°F-113°F / 0°C-45°C).

For further assistance, please contact customer support.

6. Specifications

7. Warranty & Support

The BuSwift 320P Robotic Pool Cleaner comes with a 1-year warranty. We are committed to providing worry-free customer service.

Have any questions or require assistance? Please reach out to us anytime, and we'll be there to help.

For support, please visit the official BUBLUE Store on Amazon or contact us through the platform.

Official BUBLUE Store: BUBLUE Store